indy E3 Exeter LED Acrylic Reflector Instruction Manual

June 9, 2024
indy

indy E3 Exeter LED Acrylic Reflector Instruction Manual
Luminaires Ordered

IMPORTANT SAFEGUARDS

WARNING: When using electrical equipment, always adhere to basic safety precautions including the following: This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1. Disconnect Power
    • Always disconnect power during installation and maintenance.
  2. Remove Top Plate
    • Loosen the screws (do not remove) in the top of the housing. Twist off the cover.
  3. Mounting

Stem Mount – Minimum stem length

E3: 3/8″ to 3/4″ Stem

  • Thread the stem into the hub
  • Tighten the set screw.

Cable Suspension E3 Series:

  • To install with cable suspension follow the instructions provided with the kit.
    Note: The fixture must be ordered with provision for cable suspension
    Cable Suspension

Connect Wires

Incandescent

  • Connect lamp-holder leads to the appropriate 120V leads

Integral Driver LED

  • Check line voltage. Fixtures for 120V through 277V use auto sensing multi voltage drivers. Fixtures for 327V or 480V are furnished with transformer to bring voltage down to 277V.
  • Connect leads to proper voltage

For All Light Sources

  • Attach the leads using approved connectors
  • Individually cap all unused leads.

Integral Ballast (Electronic – Compact Fluorescent

  • Check Voltage
  • Luminaire may be furnished with single voltage or auto sensing multi-voltage ballast.
  • Connect leads to proper voltage

Remote Ballast Compact Fluorescent

Single Lamp

  • Connect leads to the ballast secondary.

Multiple Lamp – “Plug & Play”

  •  Attach the stem to the remote ballast assembly.
  • Attach the mounting plate ① to the stem.
  • Push the wires up the stem, then follow the instructions supplied with the remote ballast to plug the color coded wires into the compact fluorescent ballast.
  • Connect the wiring harness supplied with the luminaire ② to the ballast assembly as illustrated.
  • Attach luminaire to the mounting plate ① and tighten the screws.
    Multiple Lamp

Hang Luminaire

  • Mount luminaire on the cover plate and tighten screws.

Install Lamp(s) (Incandescent and CFL only)

  • Observe the lamp manufacturers recommendations and restrictions.
  • Remove and install compact fluorescent lamps by grasping only the plastic portion of the lamp

Luminaires Ordered with Deco-Lens

  • To prevent breakage, the E3 Series Deco-Lens is shipped separately.

  • To install the Deco-Ring, insert the plastic washers above and below the glass lens and secure with the decorative thumb screws provided.
    Luminaires Ordered

  • 1300 S. Wolf Road

  • Des Plaines, IL 60018

  • Phone 1-800-705-SERV (7378)

  • Visit us at www.acuitybrands.com/Indy ©2017 Acuity Brands Lighting, Inc. Rev 4/17 Z-12093

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals