SATCO 43T8 Tube Bulb43T8 Tube Bulb Instruction Manual
- June 9, 2024
- SATCO
Table of Contents
Operation Instruction
— Double ended By Pass/Line Voltage
Product Name: LED T8 Tube Series
Product Model: 43T8/LED/96-8XX/BP/R17d
Product Models Included:
43T8/LED/96-835/BP/R 17 d
43T8/LED/96-840/BP/R17d
43T8/LED/96-850/BP/R17d
Product Features:
■ UL certified
■ Full glass housing: No Aging, Yellowing, Bending.
Product Applications:
Widely used in residential buildings, offices, shopping malls, oupermarkets, hospital•. assembly lineo, warehouses, etc. for energy saving illumination.
lnstallation Instructions:
Please completely comply with theoe inotruction• and noteo, to enoure that the product io operated in a sale condition.
Safety Precautions:
For your and others’ safety, please read !he precaution carefully before installation:
- Product should be inotallad by quallfled electrlclan.
- Switch off !he power supply before commencing work, make sure correct connection before power on.
- NOT FOR EMERGENCY LIGHTING.
- OPERATED WITH METAL FIXTURE ONLY
Wiring Instruction- Electronic Ballast
Wiring Instruction- Magnetic Ballast
WARNING – Risk of fire or electric shock. LED Retrofit Kit installation
requires knowledge of luminaires electrical systems. If not qualified, do not
attempt installation. Contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this kit only in the
luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrofit kit
does not exceed the input rating of the luminaire.
Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
WARNING -To prevent wiring damage or abrasion, do not expose wiring to
edges of sheet metal or other sharp objects.
Installers should not disconnect existing wires from lamp holder terminals to
make new connections at lamp holder terminals. Instead installers should cut
existing lamp holder leads away from the lamp holder and make new electrical
connections to lamp holder lead wires by employing applicable connectors.
THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERETHE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY UL OR AUTHORITIES HAVING
JURISDICTION.
THERE ARE LED TUBE, OPERATION INSTRUCTION AND FIELD APPLIED LABEL IN THIS
RETROFIT KIT.
The units covered by this report were intended to retrofit surface mount with
diffuser for these models,Type IC or non-IC recessed mount listed fluorescent
luminaires that use maximum two tubular lamps, the minimum lamp compartment
dimensions are tabulated below:
Model Number| MINIMUM LAMP COMPARTMENT DIMENSIONS [Length x Width x Height]
[cm]| Lamp Quantity
---|---|---
43T8/LED/96-8XX/BP/R17d| 244 x 27 x 7| 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)this device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>