Onninen HID HPL-SON Pro LED High Power Instruction Manual
- June 9, 2024
- onninen
Table of Contents
Pro Led High Power
HID HPL/SON replacement
Mounting instructions
HID HPL-SON Pro LED High Power
Please read through the installation manual below before the work starts. The guideline contains important information for product installation guidance and safety.
Safety instruction:
- Always switch off the power supply before the wiring and installation work.
- Check the luminaire and lamp holder are in good condition before the installation.
- The product can be operated on Direct Mains or Electro Magnetic (EM) gear without ignitor. Ignitor always needs to be disconnected from the system.
- Recommended to remove capacitor to improve system power factor.
- To ensure the product safety, do not change the structure or any components of the product.
- The product should be installed by professional electrician.
- Depending on the differences of lighting/luminaire system, the total product performance may vary.
- Suitable for use in operating temperature range between -30°C to +40°C.
- Recommended not to use in open luminaire.
- The product is NOT dimmable.
For replacing HPL/SON/Other lamps, convert to direct mains (recommended) For replacing HPL lamps and keeping the EM ballast
- After capacitor is removed, open wires should be terminated properly.
- If capacitor remains the power factor might be lower.
For replacing SON lamps and keeping the EM ballast
- After capacitor is removed, open wires should be terminated properly.
- If capacitor remains the power factor might be lower.
Airam Electric Oy Ab, Sementtitehtaankatu 6, FI-04260 Kerava, Finland,
www.airam.fi
2022.07.13
Documents / Resources
|
Onninen HID HPL-SON Pro LED High
Power
[pdf] Instruction Manual
HID HPL-SON Pro LED High Power, HID HPL-SON, Pro LED High Power, LED High
Power, High Power, Power
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>