ECG TV 3030 Heat R Hot Air Ventilator Instruction Manual

: June 9, 2024
: ECG

Table of Contents

ECG TV 3030 Heat R Hot Air Ventilator
DESCRIPTION
SAFETY INSTRUCTIONS
USING THE APPLIANCE
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ECG TV 3030 Heat R Hot Air Ventilator

ECG-TV-3030-Heat-R-Hot-Air-Ventilator-product-image

DESCRIPTION

Function switch
Temperature control
Air vent cover
Power On

Before any manipulation with the device, always turn the thermostat control to minimum, switch the device off using the function switch and unplug it. You will limit risk of injury by electric shock.

SAFETY INSTRUCTIONS

Read carefully and save for future use!
Warning: The safety measures and instructions, contained in this manual, do not include all conditions and situations possible. The user must understand that common sense, caution and care are factors that cannot be integrated into any product. Therefore, these factors shall be ensured by the user/s using and operating this appliance. We are not liable for any damages caused during shipping, by incorrect use, voltage fluctuation or the modification or adjustment of any part of the appliance.
To protect against a risk of fire or electric shock, basic precautions shall be taken while using electrical appliances, including the following:

Make sure the voltage in your outlet corresponds to the voltage provided on the appliance label and that the socket is correctly grounded. The outlet must be installed in accordance with applicable electrical codes according to EN.
Do not operate the heat convector without the base properly attached.
Do not operate the device if the cord is damaged. All repairs, including cord replacements, must be carried out at a professional service centre! Do not remove the protective covers from the appliance; there is a risk of electric shock!
Protect the device from a direct contact with water and other liquids in order to prevent injury from electrical shock.
Do not use the convector outside or in wet environment and do not touch the power cable or the device with wet hands. Risk of electric shock.
Be cautious when using the convector near children!
Make sure the convector is placed on a flat surface.
Do not use the convector close to flammable objects or underneath them, e.g. curtains. The temperature of the surfaces near the convector may be higher while it is in operation than usual. Place the convector to ensure sufficient air circulation.
Do not place the convector on a high pile carpet.
Do not place the convector in front of or directly under an electric socket.
Do not cover the heat convector! In case of covering it there is a risk of overheating of fire.
The convector must not be connected to the electrical outlet via a timer or connected to a remote switching power circuit, as in the case of remote switching on the covered or incorrectly placed convector there is a risk of fire.
Do not use the convector close to a bathtub, shower or a pool and do not place it in locations where is a danger of it falling into a bathtub or another container with water!
If the device emits an abnormal smell or smoke, immediately unplug it and have it checked by a service centre.
Do not switch off the device by pulling on the power cord. Always turn off the main switch of the convector first!
Always unplug the convector when moving it to another location.
Do not leave a convector with inserted power cord unsupervised. Disconnect the cord from the electrical outlet prior to any maintenance. Do not unplug the device by pulling the power cord. Unplug the power cord from the outlet by grasping the plug.
Do not allow the power cord to touch hot surfaces or run the cord over sharp edges.
Do not use the convector in places where flammable materials are stored (paint, gasoline, solvent etc.) or where there is a risk of flammable fumes appearing.
Do not put your fingers or other objects into the openings of the heat convector.
Do not cover the output vents by e.g. a towel or dry any laundry on it.
Use the convector only according to the instructions provided in this manual. The manufacturer is not liable for damages caused by the improper use.
This appliance can be used by children aged 8 years and older and people with lower physical or mental abilities or lack of experience and knowledge, if they are supervised or have been instructed to use the product in a safe manner and understand the potential dangers. Children must not play with the appliance. User cleaning and maintenance must not be performed by unsupervised children. Children under 8 years old must keep away from the appliance and its power supply.
- Children under 3 years of age may not be near the device unless constantly supervised.
- Children aged 3 to 8 years can turn the appliance on and off only if it is properly placed and installed in its correct working position when they are under supervision or have been instructed on the use of the appliance in a safe way and understand the potential dangers. Children aged 3 to 8 years are not allowed to plug the appliance, set controls, clean it or perform user maintenance. WARNING: Some parts of the appliance may be hot during operation and can cause burns. It is necessary to exercise caution in the presence of children or persons with physical or mental impairments.

Do not immerse in water!
WARNING: This heater is not equipped with a device for measuring the room temperature. Do not use the heater in small rooms occuppied by individuals that are not capable of leaving the room without assistance, unless proper supervision is available.

DO NOT COVER!
WARNING: To prevent overheating, do not cover the heater.

Requirements on installation
Place the hot air ventilator on a flat surface with a sufficient amount of space around the appliance to ensure the proper function of exhaust vents. Between the device and surrounding objects must be a distance of at least 90 cm.

USING THE APPLIANCE

This hot air ventilator uses hot air technology with temperature regulation. You can set the required output level by turning the function switch:

= off
= fan only
= low 1000 W
= higher output 2000 W

The red indicator light indicates the hot air ventilator has been turned on.

Turn the thermostat control clockwise to maximum.
When the required temperature in the room is reached, turn the thermostat control counterclockwise until you hear light click indicating that the thermostat is off. The hot air ventilator and indicator light is turned off.
The device now maintains the set room temperature. As soon as the room temperature drops, the hot air ventilator will automatically switch on and after reaching the desired room temperature, will again automatically switch off.

Safety thermal fuse

The device is also equipped with a safety thermal fuse, which automatically switches the device off if it experiences overheating.
In the event of overheating, switch the fan off using the function switch, unplug it and let cool at least 10 minutes. Afterwards, you may connect the device and turn it on again.

CLEANING AND MAINTENANCE

Unplug the device and let it cool down before cleaning. Clean the outer surface of the hot air ventilator with a damp cloth. Do not use sharp or abrasive agents to clean the device, otherwise the surface can become damaged.
The hot air ventilator can be put away only after it has been properly turned off, disconnected from the outlet and cooled down.

TECHNICAL SPECIFICATIONS

Max. input power 2000 W 3 heat settings
Function cool / warm/ hot air (1000 / 2000 W)
Continuous thermostat regulation
Safety cut out switch
Power on indicator
Integrated handle for easy portability
Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 2000 W
Noise level: 35 dB

USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic recycling containers.

DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste. Hand over the product to the specified location for recycling electric and electronic equipment. Prevent negative impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product, refer to your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.

English| Model identifier for electric local space heaters
---|---
Type number:| ECG TV 3030 Heat R
Item| Symbol| Value| Unit
Heat output
Nominal heat output| Pnom| 2.0| kW
Minimum heat output (indicative)| Pmin| 1.0| kW
Maximum continuous heat output| Pmax,c| 2.0| kW
Auxiliary electricity consumption
At nominal heat output| elmax| N/A| kW
At minimum heat output| elmin| N/A| kW
In standby mode| elSB| N/A| kW
Type of heat input, for electric storage local space heaters only (select one)
Manual heat charge control, with integrated thermostat| NO
Manual heat charge control with room and/or outdoor temperature feedback| NO
Electronic heat charge control with room and/or outdoor temperature feedback| NO
Fan assisted heat output| NO
Type of heat output/room temperature control (select one)
Single stage heat output and no room temperature control| NO
Two or more manual stages, no room temperature control| NO
With mechanic thermostat room temperature control| YES
With electronic room temperature control| NO
Electronic room temperature control plus day timer| NO
Electronic room temperature control plus week timer| NO
Other control options (multiple selections possible)
Room temperature control, with presence detection| NO
Room temperature control, with open window detection| NO
With distance control option| NO
With adaptive start control| NO
With working time limitation| NO
With black bulb sensor| NO