LANCOM XS-5116QF System GmbH User Guide

June 4, 2024
LANCOM

LANCOM-logo

LANCOM XS-5116QF System GmbH

LANCOM-XS-5116QF-System-GmbH-product

SECURE. NETWORKS.

LANCOM-XS-5116QF-System-GmbH-fig-1

  1. Configuration interfaces RJ-45 & micro USB (Console) Connect the configuration interface a via the included serial configuration cable to the serial interface of the device you want to use for

  2. configuring/monitoring the switch. Alternatively use the interface b with a suitable micro USB cable.

  3. USB interface
    Connect a USB stick to the USB interface to store general configuration scripts or debug data. You can also use this interface to upload a new firmware.

  4. SFP+ interfaces 1G/10G Insert suitable LANCOM SFP modules into the SFP+ interfaces 1 to 12. Choose cables which are compatible with the SFP modules and connect them as described in the SFP modules mounting instructions www.lancom-systems.com/SFP-module-MI.

  5. SFP+ interfaces 1G/10G (combo ports) Insert suitable LANCOM SFP modules into the SFP+ interfaces 13 to 14. Choose cables which are compatible with the SFP modules and connect them as described in the SFP modules mounting instructions www.lancom-systems.com/SFP-module-MI.

  6. TP Ethernet interfaces 1G/2.5G/5G/10G (combo ports) Connect the interfaces 13 to 14 via Ethernet cables to your PC or a LAN switch.

  7. QSFP+ interfaces 40G Plug suitable LANCOM QSFP+ modules into the QSFP+ interfaces 15 to 16. Select cables suitable for the QSFP+ modules and connect them as described in the SFP modules mounting instructions www.lancom-systems.com/SFP-module-MI.LANCOM-XS-5116QF-System-GmbH-fig-4 2 slots for power supply modules with mains connection socket (rear panel) To install a power supply module, remove the appropriate module slot cover by loosening both associated screws and insert the power supply module. Supply the device with voltage via the power supply module mains connector. Use the supplied power cord (not for WW devices) or a country -specific LANCOM power cord. To remove a power supply module, disconnect the device from the power supply and pull the power plug out of the module. Then push the release lever I to the left. Now you can pull the module out of the device by the handle J.LANCOM-XS-5116QF-System-GmbH-fig-5

Please observe the following when setting up the device

  • The mains plug of the device must be freely accessible.

  • Do not rest any objects on top of the device and do not stack multiple devices.

  • Keep the ventilation slots of the device clear of obstruction.

  • Mount the device with the enclosed rack mounting system in a free 19” slot of an appropriate server rack. Both slide-in rails are attached as shown in the accompanying installation instructions
    www.lancom-systems.com/slide-in-MI.

  • Please note that support for third-party accessories (SFP and DAC) is not provided.

Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide!Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times. LANCOM-XS-5116QF-System-GmbH-
fig-6LANCOM-XS-5116QF-System-GmbH-
fig-7LANCOM-XS-5116QF-System-GmbH-
fig-8

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals