meliconi L4483349-N Easytel TV User Guide
- June 9, 2024
- meliconi
Table of Contents
meliconi L4483349-N Easytel TV
- The Easytel TV+ remote control is a universal remote control. For this reason it must be programmed by following the procedure listed below.
NOTE
- The remote control reproduces the infrared signals of the original remote control. Radio frequency functions (e.g. voice commands and pointer) are not supported.
- Press and hold button 5 and check that the LED on the remote control remains continuously lit until the button is released. If the LED flashes or stays off the batteries used are not sufficiently charged: replace them
SAFETY WARNING
The remote control and the batteries must not be exposed to excessive heat sources, such as the sun’s rays, fire or similar. This product is not a toy, and must not be left within the reach of children or pets. The crossed-out bin symbol shown on the product indicates that it must be collected separately from other waste at the end of its useful life. Users must therefore take it to the appropriate separate waste collection centres for electrical and electronic waste, or hand it in to the retailer when purchasing a device of the same type. Proper separate waste collection for end-of-life devices so they can be sent for recycling, treatment or eco-compatible disposal helps to avoid possible negative effects for the environment and health, and aids recycling of the materials the device is composed of. N.B.: Batteries must not be taken apart, thrown into the fire or dispersed in the environment. Improper use may cause damage to the environment or health. The bin symbol indicates that batteries must be disposed of in accordance with the regulations in force; make sure you are familiar with the regulations governing the collection of worn-out batteries and accumulators in your country.
- Press and hold the “ ” button until the top LED lights up. Release the button.
- Use the numeric keys to enter the code previously found. The LED will make 3 flashes of confirmation.
- Check that the keys function correctly. If they do not all function correctly, go to point “C” below.
- Switch on the device to be controlled.
- Press and hold the “ ” button until the top LED lights up. Release the button.
- Point the remote control at the device, hold down the button and release it as soon as the device switches off (min 6 seconds – max 5 minutes)
- Check that the keys function correctly. If it does not work, repeat procedure “C” or contact customer service.
2 years warranty
MELICONI S.p.A. V. Minghetti, 10 Cadriano di Granarolo Emilia 40057 (BO) Italy www.meliconi.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>