LANCOM WDG-2 Wireless ePaper Display Instruction Manual
- June 4, 2024
- LANCOM
Table of Contents
LANCOM WDG-2 Wireless ePaper Display Instruction Manual
Mounting instructions
Place the mounting plate upright to the wall, so that the angled edge is
located at the top and points at you.
Use the mounting plate as a template to transfer the mounting screw positions
to the wall. When positioning, keep in mind that the screw heads have to be
passed through the center of the cross-shaped slots first, and then the
mounting plate is fixed by moving it vertically or horizontally within the
slots.
Depending on the wall material, you have to pre-drill first and use the
provided dowels. Screw the provided longer screws into the wall or dowels at
the previously marked positions and fasten them until the mounting plate is
fixed backlash-free, but can be moved as described above.
Now you can take the mounting plate off the wall and place it at the backside
of the display. Pay attention to the angled edge, which has to be located
behind the display and showing to it.
Align the four fastening holes in the mounting plate to the according plastic
thread holes at the display housing. Then fasten the mounting plate to the
display using the four provided short screws.
Fasten them carefully. As the last step, mount the previously created unit to
the already prepared place at the wall.
Support
© 2022 All other names or descriptions used may be trademarks or registered trademarks of their owners. This document contains statements relating to future products and their attributes. LANCOM Systems reserves the right to change these without notice. No liability for technical errors and / or omissions. 111911 05/2022
LANCOM Systems GmbH
Adenauerstr. 20/B2
52146 Wuerselen
Germany
info@lancom.de
lancom-systems.com