Cattara 13042 2 In 1 Couple Gas and Charcoal Grill Instruction Manual

Cattara 13042 2 In 1 Couple Gas and Charcoal Grill

INSTALLATION

PARTS

TOOLS

TECHNICAL INFORMATION

Heat input

| 8.4 kW(611 g/h)| ****

2575-21

Appliance category| I3+(28-30/37)| I3B/P(30)
Gas type| Butan| Propane| LPG
Gas pressure| 28-30 mbar| 37 mbar| 30 mbar
Injector size| 0,82 mm
Identification code| 2575DM28150

IGNITION
single ignition piezo ignition

CAUTION

• Read the following instructions carefully to make sure your grill is properly installed, assembled and ready to use. Failure to follow these instructions could result in serious injury and / or property damage.
• If you have any questions regarding installation or operation, contact your dealer or a specialist gas appliance company.
• When using on the ground, always place the grill and the cylinder on a firm, level surface.
• Never light the grill in the closed position.
• Compressed gas cylinders 11 kg – 15 kg can be used for this grill. The grill will perform better when using Propane or LPG.
• Butane can also be used, but due to the gas flow rate, the cylinder is likely to be covered with icing, resulting in a reduction in gas pressure, which will affect grill performance.
• The following conditions must be observed when using this grill. A distance of at least 1 meter from any obstacles must be maintained on all sides of the grill.
• There must be no obstacle above the grill.
• ANY COVERING OF THE GRILL IS NOT PERMITTED!

CONNECTION OF THE GAS CYLINDER TO THE APPLIANCE
This gas appliance is only suitable for use with low-pressure gas cylinders filled with butane, propane or LPG mixtures, equipped with a suitable low- pressure regulator and flexible hose. The hose must be secured on the controller and on the appliance with hose clips. The operating pressure of this appliance is set to 28 mbar for butane gas, 37 mbar for propane gas and 30 mbar for LPG mixtures, or 37 mbar for LPG mixtures, or 50 mbar for LPG mixtures. Use a suitable regulator certified by BSEN 12864: 2001. Consult your gas dealer regarding a suitable pressure regulator for the given cylinders.

HOSE REGULATOR

These parts are supplied with the grill, but spare parts are only available from authorized dealers or authorized gas service centers. Use only regulators and hoses approved for gas appliances with the above pressures. The service life of the controller is about 10 years. We recommend replacing the controller every five years. ź Using the wrong pressure regulator or hose is dangerous. ź Before switching on the appliance, always make sure that the regulator and the hoses are in order and that there is no risk of gas leakage. The hose used must comply with the relevant standards for the country of use. The length of the hose must not exceed 1.5 m. Worn or damaged hose must be replaced immediately. Before connecting, always make sure that the hose is not damaged, broken or in contact with parts of the appliance.

APPLIANCE STORAGE
Storing the appliance indoors is only permissible when the gas cylinder is disconnected. If the appliance is not used for a long period of time, it should be stored in its original packaging and stored in a dry, dust-free environment.

GAS BOTTLE

• The gas cylinder must be handled with care! The gas cylinder must be disconnected when the appliance is not in use. After disconnecting from the appliance, always place the protective cap on the gas bottle.
• Gas cylinders must be stored outdoors, well ventilated, upright and out of the reach of children. Gas cylinders must not be exposed to temperatures higher than 50 ° C. Do not store gas cylinders near fire, hot or hot objects, or other sources of ignition. Do not smoke or use open flame when handling or around the gas cylinder.
• This appliance is intended for outdoor use only, away from all flammable materials. No obstacle may be placed above the appliance, no objects or obstacles may be placed within 1 meter of each tent from the appliance. It is important that the ventilation openings of the appliance are not damaged or otherwise blocked. The appliance must always be placed on a flat and stable surface. The appliance must be protected against direct drafts and must be located or protected against the direct ingress of any running water (eg rain).
• The parts of the appliance sealed by the manufacturer must not be changed by the user! No modifications to the appliance are permitted. Any repairs may only be performed by an authorized service of gas equipment.

Connection to the appliance

• Before connecting, make sure that there is no dirt in the controller, in the hose or in the burner of the appliance. Spiders, insects, etc. they can easily clog gas pipes! Impermeable pipes can lead to fire!
• Only clean the burner with gas line cleaner.
• Connect the hose to the device and tighten the connection thread with a wrench. If the hose is replaced, it must be ensured that the appliance and the controller are connected by means of hose clips. Disconnect the regulator from the gas cylinder (according to the instructions supplied with the regulator) when the appliance is not in use.
• The appliance may only be used in a well-ventilated area. Do not obstruct the airflow into the burner when grilling.
• FOR OUTDOOR USE ONLY

LEAK CHECK

• Prepare a solution of water and soap in the ratio of 1 part of washing soap and 3 parts of water.
• Make sure the control valve is off.
• Connect the regulator to the gas cylinder and switch on the gas supply to the burner.
• Apply a solution of water and soap to all gas pipe joints. Where bubbles appear, there is a pipe leak that must be removed immediately.
• After repairing the leak, check again.
• After checking, close the gas supply and, if necessary, disconnect the gas cylinder.
• If a leak has been detected that cannot be removed, the appliance can no longer be used. Have the repair carried out by an authorized service center for gas appliances.

BURNER IGNITION

• Open the grill lid and turn on the gas supply.
• Push the knob and turn it to the MAX position and press the IGNITION (piezo ignition) button to ignite the burner.
• If the burner does not ignite, turn the burner control to the OFF position and repeat the ignition process.
• Adjust the burner flame by turning the knob between the MAX and MIN positions.
• To switch off the grill, first switch off the gas supply and then turn the burner control to the OFF position.

MAINTENANCE AND CLEANING

CAUTION:

• All cleaning and maintenance can only be performed if the grill is not lit, cold and the gas supply is disconnected from the gas cylinder.
• By cleaning the appliance after each grilling (approx. 15 minutes) you will achieve the best results of cleanliness and quality of food preparation.

EXTERIOR SURFACE

• Clean with a mild detergent or baking soda and warm water. Non-abrasive cleaning powders can be used on dried residues, which must then be rinsed thoroughly with water.
• If the paint is peeling off on the surface, or if the accumulated fats are baked on, which are charred and peeling on the surface, wash with hot soapy water. Rinse with water and allow to dry.
• Never use cleaners for ovens, sands, etc.

NTERIOR SURFACE – LOWER PART
Remove residues with a brush, scraper or spatula, then wash with soapy water and allow to dry.

GRILL GRID
Remove residues with a brush, scraper or spatula, then wash with soapy water and allow to dry.

CLEANING OF THE BURNER

• Only clean the burner if the gas cylinder is disconnected.
• Remove the grate.
• Clean the burner with a soft brush or blow out with compressed air and then wipe with a cloth.
• Clean any clogged nozzles with a needle or hard wire (eg an open paper clip).
• Check the condition of the burner regularly (cracks and holes). In case of damage, the burner can no longer be used.

SERVICE
This gas appliance must be inspected every year by an authorized gas appliance service center.

DECLARATION OF CONFORMITY

We : Jiang Men City Hong Hua BBQ Grill Co., Ltd Xinjian Development Zone, Siqian Town, Xinhui District 529159, Jiang Men City , Guang Dong , China declare under our sole responsibility that the following product

Gas BBQ Grill Unit
Hong Hua Model: G9003CT
COMPASS Model: 13042

Is in conformity with the
EX Type-Examination Gas Appliance Directive EU 2016/426 & Standard EN 498:2012 & EN 494:2019
Intertek Italia S.p.A. Via Miglioli, 2/A – 20063 Cernusco sul Naviglio, Milano – Italy (Notified Body 2575), Certificate No. ITS-2575-GAR-2128150, Date of issue 25.1.2021, Valid until 24.1.2031
and the following harmonised standards and technical specifications have been applied:

We declare under our sole responsibility that when the products identified above to which declaration relates, are supplied to other non-English speaking countries of European Economic Area , their technical instructions , packaging , markings and appliance markings will contain the same technical information as the EC type-examined version and will be in the official language of those countries.

Economic Area countries are listed as below:

GB,IE: — English LU — German
SE:- — Swedish
CZ: — Czech Republic
FR: — French
NL: — Dutch
FI: — Finnish
SK: — Slovak Republic
DE: — German
DK: — Danish
IT: — Italian
AT: — German NO —
Norwegian ES: — Spanish

• This appliance , it controls and ancillary parts do not contain asbestos nor any substance that could constitute a hazard to health. Furthermore , any appliance submitted will not be electrically unsafe.
• The material used are appropriate for their intended purpose and can withstand the technical, chemical and thermal conditions to which they will foreseeable be subjected.
• The properties of materials important for safety are hereby guaranteed by the manufacture or supplier of appliance.

Jiang Men City, 19/8/2021
Jiang Men City Hong Hua BBQ Grill Co.,Ltd
XIE Yanming , Sales Director

ADDRESS: Compass CZ s.r.o. Pražská 17, 250 81 – Nehvizdy, CZ,
e-mail: info@compass.cz

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>