gosund SW2 Dimmer Smart Switch Instructions
- June 8, 2024
- gosund
Table of Contents
SW2
Dimmer Smart Switch Instruction
Product Overview
Before you install
WARNING! RISK OF ELECTRIC SHOCK.
Incorrect installation could be dangerous or illegal, multiple breakers may
need to be de-energized for safe installation. Please call a professional
electrician if you are unfamiliar or uncomfortable with electrical work.
Note: a
non-metalized type listed face plateshall be employed for installation Make
sure your wiring is compatible. The smart dimmer switch replaces single pole
switches only. If your light can be turned on from two different wall
switches, that’s a 3-way switch and dimmer smart switch Is not compatible.
Note: This device features easy-to-use technology making it simple for
you to control your dimmable lighting.Smart bulb can’t be dimmed by this
switch.
Install the Light Switch
Step 1: Shut OFF the power at the circuit breaker for the switch you are
replacing. You may need to shut OFF more than one circuit breaker/switch to
make sure the switch you’re working on is powered OFF.
IMPORTANT: USE A NON-CONTACT VOLTAGE DETECTOR OR FLIP YOUR LIGHT SWITCH A
FEW TIMES TO MAKE SURE THAT THE POWER IS OFF
Step 3: Identify the wires on your device as follows
Step 4 : Install the smart Light Switch. Connect two wires from the smart
Light Switch to the available Switch ( Live / Load ) wires . In case you found
more than one wire just place them into the wire nut .
NOTE : The wire nut is the cap-like object connecting the wires
Step 5 : If you have a wire ( optional )disconnect it from the old switch
and connect it to the green wire on the Switch.
Step 6 : Unscrew the wire nut that is holding together the existing
Neutral wires. Connect the white wire from the smart Light Switch to the
outlet’s exposed Neutral wires. Securely screw them together inside the wire
nut.
Parameters
Model: SW2
Input: 120V- 50/60Hz 4A
Output: 120V – 50e31-lz 4A Max for General use: 1.245. FLA Motor
Power Supply Mode: Neutral+Live
Wire Wi-Fi 802.11 NO, 2.4GHz(only)
Operating Temp. 0-40 °C
Operating Control
Type 1
Pollution Degree: 2
Impulse Voltage: 2500V
Reset
Turn on the power. bold the Reset button for 5 seconds and let it go when the Switch starts to flash quickly, the reset is successful. When the Switch is in a new network environment, you need to restore the factory settings, and then reconnect to the network.
Warnings and Precautions
- Keep it out of the reach of children and pets.
- Do not use this product in humid environments or outdoors. Ifs for indoor use only.
- Do not place this product near heating devices, such as microwave ovens, stoves, or radiators.
- Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, flammable gases, vapors and solvents.
- Do not disassemble, modify, or repair your device, and ask help from the authorized professionals for device malfunction.
- Do not use the device when it is no longer working properly or visibly damaged.
- Do not store the device for extended periods in poor ambient conditions.
- Never use aggressive detergents such as rubbing alcohol or other chemical solutions because these could damage the casing or even impair the functioning of the product.
Note: The image shown in the manual is indicative only. If there is inconsistency between the image and the actual product, the actual product shall govern.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>