egg Smart Motion Rocker Instruction Manual

: June 1, 2024
: EGG

Smart Motion Rocker

smart motion rocker

INSTRUCTION MANUAL

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.

Your child’s safety may be affected if you do not follow these instructions.
Use only spare parts delivered by the manufacturer for replacing parts or repairs.
Damage caused by overloading or incorrect folding are not covered by the warranty.
Prolonged exposure to sunshine may cause changes in the colour of materials and fabrics.
Do not expose this product to extreme temperatures. Extreme sunshine or temperatures may cause colour changes or bent parts.

WARNING:

Never leave the child unattended.
Stop using the product when the child starts trying to sit up. • Never use this product on an elevated surface (e.g. a table).
Always use the restraint system.
Never use the toy bar to carry the product.
Do not move or lift this product with the baby inside it.
Never let the child sleep in this product. This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.
Do not use the product if any components are broken or missing.
Do not use accessories or replacement parts other than those approved by the manufacturer.

IMPORTANT:

Adult assembly required.
Use for babies aged up to 6 months with maximum weight 9kg.
Do not use the product for more than one child.
The product is not a substitute for a cot or bed. If the child needs sleep, you should put them in a suitable bed or cot.
Do not use the product if there are missing or damaged parts.
If parts are missing or broken, please contact the store where you bought the product, before using.
The manufacturer revokes all responsibility in case you have used spare parts different from the approved type or not recommended by the producer.
Keep away from fire.
Do not tie strings or cords to the product to avoid risk of suffocation.
All settings regarding the power supply – turning on/off, replacing or charging of batteries to be done only by adult.
Use only the AC/DC adaptor supplied by the manufacturer.
Regularly check the good working order of the AC/DC adaptor. Discontinue use in case of damage.
Do not allow presence of children under 3 years before assembly is complete to avoid their access to small or disassembled parts.
Do not rotate the seat by 90 degrees when swing mode is on as it may damage the swing mechanisms.

WARNING:

Please keep all packaging material away from babies and children, to prevent suffocation.

Remote control powered by coin/button batteries

WARNING:

This product contains a coin/button battery. A coin/button battery can cause serious internal chemical burns if swallowed.

Dispose of used batteries immediately. Keep new and used batteries away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

Manufactured and tested in compliance with EN 12790-1:2023

COMPONENTS

The illustrations in this manual are used to demonstrate the operation of the product. Where there are small differences between the physical object and the illustrations, the physical product shall prevail.

INSTALLATION

Install bottom tubes:
Insert the two bottom tubes into the main frame (figure 1-1).
Press the spring plate and insert, the tubes are inserted correctly when the spring plate pops out the hole (figure 1-2).

Seat frame installation:
Insert the seat frame on top of the main frame (figure 2-1). When you hear a‘click’ it is installed correctly.
If you don’t hear the sound, push it down slightly until you hear it (figure 2-2).

Seat installation:
With the main frame on the ground, gently insert the seat onto the support frame (figure 3-1), until you hear a
‘click’. Check it is installed correctly before use (figure 3-2).

Toy bar installation:
Attach the toy bar to the seat back from underneath (figure 4).
Starting from underneath, hook the bar onto the frame (figure 4-1) and then
push the toy bar upwards until it snaps onto the seat frame (figure 4-2).

INSTRUCTIONS FOR USE

1. Power supply
It is recommended to use 12V-2A adaptor power which is standard with this product. Plug the adaptor included
with the product into the 240V output socket in the household. Plug the other end of the adaptor (round port) into
the DC jack on the right of the main frame (Figure 5). It is recommended for indoor use away from damp places.

2. Touch screen panel functions

2.1 Power switch: Press the power button to turn on/turn off; when the swing is
working, pressing this button will turn off all functions including music and timer.

2.2 Timer: Use this button combined with the plus (+) and minus (-) keys to adjust the
timing of the swing. The timer is up to 45 minutes, starting at 10 minutes and
increasing with every press of the timer button in a cycle through 10, 20, 30, 45
minutes.

2.3 Music: Press the button to turn off/on music. You can switch through the songs
using the plus (+) and minus (-) keys. The built-in tunes will play in a loop until the
end and will start from track one upon power up.

2.4 Music volume: When the music is turned on the volume is medium. Press the plus
(+) to increase the volume up to 5 levels. Press the minus (-) button to decrease the
volume. The minimum level is 1. Level 0 mutes the music but it is still playing.

2.5 Swing Modes

2.5.1 Parents arm scene mode: This mode is an intelligent swing mode, the speed
cannot be adjusted. It is equipped with specific music and recommended to adjust
the seat to left or right 90 degrees for a better experience.

2.5.2 Pirate ship scene mode: This mode is an intelligent swing mode, the speed
cannot be adjusted. It is equipped with specific music and recommended to adjust
the seat to left or right 90 degrees for a better experience.

2.5.3 Merry-go-round scene mode: This mode is an intelligent swing mode and the
swing speed will automatically change from slow-fast-slow. The speed cannot be
adjusted and it is equipped with specific music.

2.5.4 Infinite swing mode: This mode consists of up and down swing mode and left
to right swing mode. There are 5 speeds and the music can be adjusted.

2.5.5 Up and down bounce mode: This mode consists of an up and down rocking
motion. There are 5 speeds and the music can be adjusted.

2.5.6 Left and right swing mode: This mode consists of left and right rocking motion.
There are 5 speeds and the music can be adjusted.

2.5.7 When switching between swing modes and scene modes, a blinking state of
the clicked symbol will appear. This state should blink every second, representing
that the mode switch is processing. Timings between switching for different modes
can differ, with the longest reaching 9 seconds. Once switching to a scene mode is
complete, the digital display will form a marquee and the speed adjustment will turn
off as the intelligent swing mode has commenced.

When the swing and music are on, if there is no operation for a long time, the
product will automatically stop after 45 minutes.

Press and hold the volume adjustment key and the music adjustment key at the same
time to turn of the ambient light, and then press and hold at the same time to turn on
the ambient light.

3. Remote control
The remote control will work within 4
metres of the main frame control panel.

3.1 When using the remote for the first
time, pull out the battery isolation film
from the bottom of the battery and
keep it aside. When not in use, you can
insert the isolation film back to its
original position to avoid power
consumption and prolong battery life.

3.2 Power button: Press once to turn on
the device and it enters standby mode.
Press the button again and the power
turns off.

3.3 Swing mode button: After the power is turned on, press this button to start
swinging. There are 6 modes in total which can be switched in turn by pressing this
button. The corresponding light on the main frame will light up to show which mode
is on.

3.4 Swing speed button: Press in turn to increase through the 5 speeds.

3.5 Timer button: Press once to increase by 10 minutes, through to 20, 30 and 45
minutes in a cycle. There are corresponding light indicators.

3.6 Music button: Press and the music will play. Press again to select the next track.
Songs are played on repeat in a loop. Long press this button to turn off the music.

3.7 Volume button: When the music is playing, the default volume of the system is
medium. Press this button and the volume will increase by one level, until the
maximum of 5. Level 0 mutes the music but it still plays.

4. Seat adjustment
There are 3 angles for this seat. Press the backrest
adjustment buttons either side of the seat at the same
time to adjust the angle (Figure 6).
DO NOT adjust the seat angle when a child is in the
seat.

5. Seat rotation
Hold the seat with both hands as displayed in
Figure 7 to rotate. You do not need to press
the buttons in. The seat can rotate only 90
degrees left and right.
The seat cannot be rotated 360 degrees.
NOTE: Do not rotate the seat when swing
mode is on as it may damage the swing
mechanisms.

PRODUCT DISASSEMBLY

Remove the seat: Press the spring plate as shown by the
arrows in Figure 8 and then pull up the seat on the left and
right sides respectively.

Remove the seat support frame: Press the button in Figure 9
and lift the frame with both hands to remove.

Remove the bottom tubes: Once you have removed the
seat and support frame, put the main frame upside
down, press the spring plate and pull out the tube
(Figure 10).

ADDITIONAL INFORMATION

After connecting the power, you can press the music button to start the music
without being in swing mode.

The motor has a protection mechanism: When the product is in swing mode and
blocked by an external force, the product will detect the swing is blocked and
automatically stop all functions. Turn off the power supply and turn back on to work
normally away from the obstruction.

Mode characteristics: Parents arm mode, Pirate ship mode and the Merry-go- round
mode have fixed speeds, it cannot be adjusted. For Parents arm mode and Pirate
ship mode, the seat should be rotated 90 degrees.
Usage of harness: First unfasten the safety harness and place in a suitable position.

Then place baby in the swing and buckle the seat belt and waist belt together. The
safety harness must be used to ensure baby’s safety.

CLEANING AND MAINTENANCE

Seat cleaning: The fabrics on the seat cannot be removed for cleaning. If you need to
clean them, use a damp cloth and mild detergent, and dry thoroughly. Do not wash
directly with water. This product is not waterproof, wipe frames with a damp cloth
and dry.

To prolong the life of your nursery product, keep it clean and do not leave in the
direct sunlight for extended periods of time.
Do not use abrasive cleaners. Do not soak in water.
Always store your product in a clean dry place.

Do not leave in the boot of car.
Avoid exposure to salt water, as this may encourage the formation of rust. If product
is used in this environment completely clean your product afterward to remove sand
and salt from mechanisms.
Should parts become stiff, squeak or difficult to operate ensure dirt is not the cause.
When storing product, never stack other items on top of it, this may damage the
product.

Do not dry clean or use bleach.
In some climates the parts may be affected by mould and mildew. To help prevent
this occurring, do not fold or store the product if it is damp or wet. Always store the
product in a well ventilated area.

Always check parts regularly for tightness of screws, nuts and other fasteners, tighten
if required. To maintain the safety of your nursery product, seek prompt repairs for
bent, torn, worn or broken parts.
Use only parts and accessories approved by the supplier

WARRANTY POLICY

KEEP YOUR ORIGINAL RECEIPT OF PURCHASE SAFE

WITH YOUR WARRANTY INFORMATION

It will be required should you unfortunately find a defect. The receipt must show the
date of purchase clearly. In the first instance you must contact the original place of
purchase. Exchanging or returning the product cannot be requested. Repairs to any
part of this product do not extend the warranty period. Do not return your product
direct to the manufacturer.

DISCLAIMER

Whilst we believe the information set out in this instruction manual to be correct and
reliable at the time of print, we do not accept responsibility for its accuracy and we
shall not be liable for its interpretation and its use. We reserve the right to change,
modify, add or delete product specifications at any time without prior notice.

YOUR WARRANTY POLICY

At BabyStyle, we guarantee your product has been manufactured in accordance with
all current European safety standards which are applicable to this product, and that
this product is free from any defects in workmanship and material at the time of
purchase. During the production process this product has gone through rigorous
quality checks. Despite our efforts, if this product does show a manufacturing or
material defect within the 24 months warranty period for the frame and 6 months for
the fabrics we will comply to the warranty terms and conditions providing the
product has been used for normal use as described within the instruction manual
and it has been maintained correctly as described in the instruction manual, for
further information please contact the place of purchase. Please retain your original
receipt of purchase safely.

WARRANTY TERMS

Frame: 24 consecutive months.
Fabrics: 6 consecutive months.
The warranty only applies to the original purchaser and is non-transferable.

The warranty will be invalidated in the following circumstances:

The product has not been used for its purpose other than described
within the instruction manual.
If the product is returned for repair through a dealer not authorized by us.
If the original receipt of purchase cannot be provided.
If the defect is as a result of improper use or incorrect maintenance,
negligence or impact damage.
If the parts show normal wear and tear that may be expected from daily
use of the product.
The warranty of this product becomes valid from the date of purchase as
stated on the original receipt of purchase. This does not affect your
statutory rights.

Register your product today at babystyledirect.co.uk.

NOTE:
The music production comes from:
EarLing.com https://www.ear0.com/sound/10262
Starry Sky License: CC-BY Author Xia Yijie
The sound of cicadas in the mountain village at night License: CC-BY Author: Yu Yu
Tian Shui License: CC-BY Author: ouning
Car racing field recording License: CC-BY
Classical Guitar Solo License: CC-BY Author: lucasgonze
Chord music for ukulele License: CC-BY Author: qubodup

We are proudly part of the

b-p-a.org

egg
36 Charles Street, Sileby,
Leicestershire LE12 7RJ
United Kingdom
T: 01509 816444
E: info@babystyle.co.uk
babystyle.co.uk
©BabyStyle UK Ltd. AW12122023