Gymax GYM08652 7 ft. Pre-Lit Artificial Christmas Tree Fiber Optic Xmas Tree Instruction Manual
- June 8, 2024
- GYMAX
Table of Contents
Gymax GYM08652 7 ft. Pre-Lit Artificial Christmas Tree Fiber Optic Xmas Tree
PRODUCT ASSEMBLY
-
0pen the base, and place the bottom section of tree on it.Screw the base and the bottom section of the tree with 3 screws.
-
0pen the branches carefully Start at the bottom. and arrange each layer evenly.
-
Connect the top section of the tree in the bottom section. And connect the circular plug and 4-pin electric wires from part A to the corresponding wires on part B.
-
0pen the branches of the top section branches. each each layer evenly.
-
0pen every tips like flower of each branches.
-
After opening all branches, adjust the tree to make it look better. The whole look is shown in the picture.
-
Finally connect the wires of the tree to the wires of the transformer.
CAUTION
- Firmly secure all screws before use.
- Product is intended for indoor use only.
- Do not place this tree in a wet location.
- This seasonal product is not intended for permanent installation or use.
- Do not use or store this item in the proximity of open flame ,flammable/combustible chemicals .or other strong heat sources.
- If any parts are missing, broken ,damaged ,or worn. stop using this item until repairs are made and/or factory replacement parts are installed.
- Do not use this item in a way that is inconsistent with the manufacturer’s instructions as this could void the product warranty.
CLEANING & STORAGE
- Store this tree in a cool and dry place away from heat and moisture.
- Before putting this tree in storage,do the following.
- Completely remove all decorations.
- Clean the tree with a slightly damped cloth and let it dry naturally.
- Raise all branches to original upright position;make sure not to damage any branches in the process.
HARDWARE
WARNING: There are plastic caps on the end of each pole that are useless.
Please make sure remove them before assembling.
-
SCREW 3PCS
-
CAP
If the caps were broken or missing, please don’ t worry.
PARTS
TROUBLE SHOOTING
- If lights/fiber optics are not working, or one section of lights does not work .make sure that all the connections are properly connected .
- If lights/fiber optics continue to not work ,take note of which lights/fiber optics are nonfunctional(al l lights, one section. Or individual lights),and contact our customer service line.
- If al l lights do not work, and all connections have been checked, please contact our customer service line and request a replacement function box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>