FURNITURE FSDH-STPKT-5-DD Sliding Barn Door Hardware Kit Installation Guide

FURNITURE FSDH-STPKT-5-DD Sliding Barn Door Hardware Kit

MODEL No FSDH-STPKT: 5-DD

WHAT INBOX

TOOLS REQUIRED

INCLUDED IN KIT

PLEASE NOTE : The installation manual is a suggested guideline. Adjustments may need to be made based on your specific application.
Architectural Products by Outwater assumes no liability for improper installation

UNDERSTANDING YOUR RAIL

INSTALLATION

Using a pencil, mark the locations where you will drill holes as indicated

1. Before beginning installation, attach the door stops [C] to the rail [L].

2. Using a power drill with a 4mm drill bit, drill holes as indicated

3. Install the rail, and mounting brackets [E].

4. Drill holes into the doors as indicated. Attach the roller straps [A].
   It is suggested that the roller straps [A] be mounted 5″ from the edge of the doors to the neck of the roller straps.
   NOTE : Trimming the rail will alter the position of the roller hardware. Adjust accordingly
   FOR ¾” DOORS
   FOR 1″ DOORS
   Allow a minimum 3-1/8″ clearance above the doors.

5. Attach the anti-jump disks [B] to the doors

6. Attach the doors to the rail [L] and lock the anti-jump disks [B] into position. Doors should be routed beforehand if using the routed door guides [G].

7. If using the routed door guides [G], install them at this time. Repeat steps 4-7 for additional door

8. Use the hole covers [K] to give the rail a finished look. The rail can be trimmed if necessary using a band saw or hacksaw. Use blades suitable for iron or stainless steel depending on your rail.
   NOTE : If you are trimming the rail, do so equally. Each rail can be trimmed equally up to 2½” on both sides. However; trimming will alter the position of the roller hardware. Adjust accordingly.

9. Once cut, add the end caps [D] to the ends of the rail and secure with a set screw.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>