meble FURNITURE BL-EF Woody Electric Fireplace TV Stand Instruction Manual
- October 30, 2023
- meble FURNITURE
Table of Contents
meble FURNITURE BL-EF Woody Electric Fireplace TV Stand
Tools required for assembly (not provided by the manufacturer)
Accessories
Assembly instructions
ELECTRIC REPLACE SAFETY INFORMATION AND WARNING
ATTENTION: This Safety Information and Warning provides basic information for using an electric fireplace insert safely. Failure to follow the recommendations and warnings below may result in risk of fire, electric shock, and injury to person and property.
- WARNING! There’s a risk of fire, electric shock, and injury to person if you don’t follow the included instruction and safety information. We are not liable for any damages or injury caused by mishandling, improper installation, or improper use of the electric fireplace insert.
- WARNING! Prior to using your electric fireplace insert, compare the rated power of the electric fireplace insert to the capacity of the electrical circuit you plan to use it within. In order for the electric fireplace insert to be safely used, the electric fireplace insert’s electrical demand, in addition to the electrical demand of any other electric devices using the circuit, should be well within the electrical capacity of the circuit. If you are unsure of the electrical capacity of the circuit, or the electrical demand of devices using the circuit, contact a licensed electrician for assistance.
- WARNING! Your electric fireplace insert may require a dedicated electrical circuit. Check with your local building codes.
- WARNING! To avoid electrical shock, do not open the back panel of the insert unless the power has been turned off and the insert has been unplugged.
- WARNING! The electric fireplace insert must be used on an AC supply only, and the voltage marked on the heater must correspond to the supply voltage.
- WARNING! Any repairs or modifications done to this electric fireplace insert are not recommended, and may cause an increased risk of fire, electric shock, and injury to person. Any repairs or modifications will void all warranty and technical support for this unit. If the decision of the user of the electric fireplace insert is to repair or modify the insert or any electrical wiring, such repairs or modifications should be done only by a licensed electrician, and must comply with local building codes.
- WARNING! Discontinue the use of this electric fireplace if any of the following has occurred:
- Water damage
- Insert has been damaged or dented
- Power cord has become broken
- Power cord has become too hot to touch
- Insert smokes or smells like smoke (Note: When the heater function is used for the first time, a slight odor may be present. This is normal and should not occur again unless the heater is not used for an extended period of time.)
- WARNING! Do not cover or obstruct the insert in any way. The insert will overheat if covered.
- WARNING! Never immerse the product in water or any other liquids.
- WARNING! Do not run cables under carpets or rugs. Do not allow the main cables to hang over the sharp edges of the electric fireplace insert. Do not allow the main cables to come into contact with hot surfaces. From time to time, check the cable for damage. Never use the electric fireplace insert if the cable or any part of the insert shows signs of damage.
- WARNING! Do not switch the electric fireplace insert on until it has been properly installed as described in the instruction manual. Do not leave the electric fireplace insert unattended during use.
- WARNING! Keep the electric fireplace insert out of the reach of children. Do not let children operate the electric fireplace insert.
- The electric fireplace insert is fitted with a safety cut-off which will trigger if the insert overheats (e.g. due to blocked air vents). For safety reasons, the insert will NOT automatically reset. To reset the electric fireplace insert, disconnect the insert from the power supply for at least 15 minutes. After 15 minutes, reconnect the insert to the power supply and switch the insert on. SAVE THIS SAFETY INFORMATION AND WARNING FOR FUTURE REFERENCE
Claim your extended 90 day product warranty by registering your product at
www.meblefurniture.com/register
ATTENTION: DO NOT RETURN THIS PRODUCT!!!
PLEASE READ THE FOLLOWING!!!
FOR REPLACEMENT/MISSING
PARTS:www.meblefurniture.com/parts
FOR INSTRUCTION/ASSEMBLY MANUALS AND VIDEOS :
www.meblefurniture.com/assembly
ALL OTHER INQUIRIE S:
help@meblefurniture.com
IF YOU ARE MISSING PARTS OR YOUR PRODUCT ARRIVED DAMAGED:
Please fill out a parts request form at
www.meblefurniture.com/parts
Replacement parts are shipped out in one business day. You will receive a
tracking number via email once your parts request has been processed.
IF YOU ARE MISSING AN INSTRUCTION MANUAL OR NEED ASSEMBLY HELP:
Please visit
www.meblefurniture.com/assembly to
access our library of product assembly videos or to download product
instruction manuals.
NOTICE REGARDING HIGH GLOSS PROTECTIVE FOIL AND PRODUCT CARE:
After removing the protective foil from the gloss fronts, the acrylic surface
of the boards is still soft and easy to scratch. With air contact, the
hygroscopic acrylic layer hardens, and the board becomes more resistant to
scratches.
It takes approximately 48 hours for the acrylic layer of the board to fully
harden.
DO NOT CLEAN, WIPE, OR POLISH THE ACRYLIC FRONTS FOR 48 HOURS AFTER REMOVING
THE PROTECTIVE FOIL!!!
GENERAL INSTRUCTIONS FOR FURNITURE OF WOOD AND WOOD MATERIALS: MELAMINE,
LAMINATE, DASHBOARD
To clean, use a damp cloth. Use only water or a mild detergent. IMpe dry with
a cloth.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>