EMOS ZS2600 Series LED Floodlight User Manual

: June 8, 2024
: EMOS

Table of Contents

ZS2600 Series LED Floodlight
LED Floodlight
Maintenance instructions:
Documents / Resources

ZS2600 Series LED Floodlight
User Manual

ZS2600 Series LED Floodlight

ZS2612	ZS2652
ZS2622	ZS2662
ZS2632	ZS2672
ZS2642

EMOS ZS2600 Series LED Floodlight - fig

Type| Input voltage| Max. power| Life span| Luminous flux| Dimensions
---|---|---|---|---|---
ZS2612| 220-240 V AC 50 Hz| 10 W| 50 000 h| 1 100 lm| 95 x 70 x 27 mm
ZS2622| 20 W| 2 200 lm| 135 x 95 x 28 mm
ZS2632| 30 W| 3 300 lm| 160 x 110 x 28 mm
ZS2642| 50 W| 5 500 lm| 200 x 145 x 28 mm
ZS2652| 100 W| 11 000 lm| 300 x 220 x 42 mm
ZS2662| 150 W| 16 500 lm| 335 x 270 x 43 mm
ZS2672| 200 W| 22 000 lm| 390 x 300 x 49 mm

This product contains a light source of energy efficiency class EMOS ZS2600
Series LED Floodlight - fig 2

LED Floodlight

LED Floodlight is designed for indoor and outdoor use to be mounted on a firm ground. Ingress Protection IP65 – for outdoor use
Mounting
Mount the Floodlight firmly onto a solid basis, for example a wall (fig. 1, 2, 3). Installation height: 2.3–3 m.
Direct the Floodlight as shown on fig. 1 and 2. L – brown – live wire
G – green&yellow – earth wire (ground)
N – blue – neutral wire

Maintenance instructions:

Before maintenance, switch off the Floodlight and wait until it is cooled.
Clean it with a soft moistened cloth.
Never submerge the Floodlight in water or other liquids.
During maintenance, observe general rules for occupational safety, and be very careful.
WARNING

The LED Floodlight is designed entirely for firm mounting.
Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be carried out only by an authorized person.
Respect a minimum distance of 1 m between the appliance and the object or surface which you wish to lighten.
If you place the Floodlight below the roof, keep the minimum 0.2 m distance measured from the upside of the Floodlight to the bottom of the roof.
When using the Floodlight on a flammable surface, observe the above instructions.
The Floodlight may only be connected to electrical mains with installation and protection that is in line with valid regulations and standards.
Before interfering with the Floodlight or performing maintenance and repair, the light fitting must be disconnected from the mains. This must only be done by a knowledgeable/experienced person within the meaning of valid regulations on qualification for such activities.
Do not use the LED Floodlight without the protection glass.
The protection from dangerous contact voltage is ensured by „earthing“.
If the external flexible cable or cord of this Floodlight is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
The light source contained in this Floodlight shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Caution, risk of electric shock .
Type Y attachment.

EMOS spol. s r.o. declares that the LED Floodlight is in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed in landfill, dangerous substances may reach groundwater and subsequently food chain, where it could affect human health.

Servis: EMOS SI, d.o.o., Rimska cesta 92, 3311 Šempeter v Savinjski dolini, Slovenija
tel: +386 8 205 17 21
e-mail: reklamacije@emos-si.si

www.emos.eu

Documents / Resources

| EMOS ZS2600 Series LED Floodlight [pdf] User Manual
ZS2612, ZS2622, ZS2632, ZS2642, ZS2652, ZS2662, ZS2672, ZS2600 Series LED Floodlight, ZS2600 Series Floodlight, LED Floodlight, Floodlight
---|---