Raingler NETS GRIPS 1999-2004 Nissan Xterra Full Ceiling Net Installation Guide
- June 8, 2024
- Raingler NETS GRIPS
Table of Contents
Raingler NETS GRIPS 1999-2004 Nissan Xterra Full Ceiling Net Installation Guide
IMPORTANT: If you model does not have factory ceiling hooks, they must be
installed first. You will need tools and hardware as shown in the video link
below.
*Production products will have black coated metal hardware, not stainless color shown. See video here for details: https://vimeo.com/316655122
Step 1
Before you get started, make sure the 6 ceiling clips are facing the correct
way. The 2005 and newer use metal hooks and normally do not need any
repositioning. The fore and aft ceiling clips need to have their largest
opening facing front to back, while the 2 center clips need to face each other
as shown in the image to the right. All 6 of the attachment straps are extra-
long to allow you to custom fit the net to your Xterra and cargo.
Step 2
Starting at the front or back, pass the straps through the ceiling clips. Loop
them around and pass them through the buckles. Do the same for the side
ceiling clips and the other end.
Step 3
The rear mounts (nearest the tailgate) should be snugged as far as they will
go for proper placement of the net.
Step 4
The side mounts should be adjusted about as shown in the image here. Once your
net is full with cargo, you can adjust the side mounts for tightness.
Step 5
(Driver’s door shown) Slide front seats forward for easiest access. Lower the
upper seat belt adjuster all the way down. From 2nd row seat area, loosen the
weather-stripping about 12″ from the front upper corner down as to allow
access to plastic B pillar trim edge.
Step 6
Grasp upper portion of B pillar trim and wiggle to pop it loose enough to
reach your hand inside (careful as edges inside may be sharp) and remove the
black or SRS equipped pop out plastic rectangle loose pushing from back side
gently. *Note: Be cautious that none of the plastic panel’s removable nylon
clips fall in the channel or pick up a few extras from us when you order your
barrier net.
Step 7
Loosen exposed 10mm black bolt.
Step 8
Fit the included Ranger C100XL hardware mount over the black 10mm bolt.
Step 9
Carefully portion the C100XL mount and the 10mm bolt to the inside mounting
hole for the bolt with the tether of the D ring strap routed up and over the
top of the B pillar trim panel.
Step 10
(Optional step for taller drivers). The upper seat belt adjuster can be raised all the way up and may barely contact the C100XL strap. If it is desired for free range of motion, trim a small edge off the contacting plastic.
Step 11
Reinstall removable rectangle piece, snap trim nylon clips into body holes and
reinstall weather-stripping while maintaining a final hardware installation
with the D ring accessible as shown.
Step 12
Once all the buckles are fastened, wrap and tuck the extra strap around and
through the buckles to get ends out of the way. See video here for details:
https://vimeo.com/316588617
Thank you for purchasing Raingler Nets. If you have any questions please
contact us, we are here to help! See all our install videos on Vimeo!
https://vimeo.com/raingler
866-905-7625 | Tech@RAINGLER.com | Raingler.com
References
- Cargo, barrier and dog safety nets - Raingler Nets
- Tying Up Loose Ends on Vimeo
- Raingler C100 Mounts for Barrier and Ceiling Installation - Trucks & Vans on Vimeo
- Raingler Nets & Barriers
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>