ECHOGEAR EGAV-ASBC62 6-Outlet Pivot-Plug Surge Protector with USB User Guide
- June 8, 2024
- ECHOGEAR
Table of Contents
ECHOGEAR EGAV-ASBC62 6-Outlet Pivot-Plug Surge Protector with USB User Guide
OPTIONAL SECUREMENT:
Your surge protector includes a mounting screw to secure the unit to your outlet and prevent accidental disconnects.
- Remove the screw holding your cover plate, leaving the cover plate in place.
- Remove the trim plate, plug the surge protector into your outlet and secure using the provided screw. Replace the trim plate.
CAUTION!: Avoid potential personal injuries and property damage!
- To Reduce the Risk of Electric Shock – Use Only in Dry Locations, Indoors!
- Ensure all of your external connections, including Satellite/Cable TV (Coax) and Phone/Ethernet (RJ45), are protected if applicable. Transient lines connected directly to your equipment without first passing through a surge protector are at risk of damage and are not covered by the connected equipment warranty.
- Due to the sacrificial properties of the internal MOV’s it is recommended that the surge protector be checked after lightning storms to verify the surge protection was not consumed.
- The input plug of this power tap is intended to serve as the disconnect device, it shall be easily accessible and withdrawn.
- This power center does not contain internal circuit breaker protection. INSTALLER MUST ensure that the input of this power center is connected individually to an electrical service panel that is protected with a UL Listed 20A (Maximum) circuit breaker for overload protection of the power center.
- Not designed for use with receptacles with indicator lights or controls as this unit will cover them.
- To reduce the risk of fire or electric shock, do not use this device with a receptacle in which the slot openings to not align with the blades.
- All accessories must be grounded.
- Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
- Surge protector must be plugged directly to the power source and must not be “daisy-chained” together (in serial) with other power strips, surge protectors or extension cords.
- Do not use this product for any purpose not explicitly specified by manufacturer.
- If you do not understand these instructions, or have doubts about the safety of the installation, assembly or use of this product, contact Customer Service or call a qualified contractor.
- Do not disassemble the surge protector. Disassembling will void the warranty and may cause serious personal injury.
- Manufacturer is not responsible for damage or injury caused by incorrect assembly or use.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Responsible Party: Legrand AV Inc., 6436 City West Parkway, Eden Prairie, MN 55344
Phone: 1-855-428-2490
Email: helpmehelpyou@ECHOGEAR.com
LEGRAND LIMITED WARRANTY AND CONNECTED EQUIPMENT DAMAGE LIMITED WARRANTY
Product Warranty
Legrand warrants to the original purchaser that the product shall be free of defects in materials and workmanship under normal use for five (5) years. When this surge protector operates properly and prevents an energy surge from damaging electrical equipment, the surge protective component will disconnect from the circuit and you will need to buy a replacement product. This warranty extends only to the original purchaser and is nontransferable during the warranty period. Legrand will, at no additional charge, repair or replace defective parts or, at its option, replace the entire unit. This warranty does not extend to any Legrand product that has been damaged or rendered inoperable as intended or defective (a) as a result of accident, misuse or abuse; or (b) by the use of parts not manufactured or sold by Legrand; or (c) by modification of the product.
Connected Equipment Damage Limited Warranty
Legrand will also provide you with a remedy for damage to connected equipment if (i) you have a claim that is covered by the limited product warranty described above, and (ii) Legrand receives a formal warranty claim from you before the end of the warranty period for damage to connected applicable to the affected product. If the conditions listed in the preceding sentence are met, Legrand will provide you with one of the following remedies, provided that it may decide at its sole discretion which remedy it provides. Legrand will (1) replace the damaged connected equipment; (2) pay to repair the damaged connected equipment; or (3) pay you the fair market value of the connected equipment, provided that such payments shall not exceed (i) the maximum coverage amount for the product, or (ii) the amount of actual damage caused by power surges due to a product defect. NOTE: Compensation for restoration of data loss is not covered AND LEGRAND DOES NOT ASSUME ANY LIABILITY FOR ANY LOSS OF PROFIT, REVENUE OR SAVING (WHETHER DIRECT OR INDIRECT) OR FOR ANY INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES UNDER THIS LIMITED WARRANTY. Protection for Network/Telephone (RJ45) or Cable/Satellite TV (CATV Coax) transient lines only applies to Legrand products which offer such protection, and in such cases, the connections must be properly installed and CATV service must be grounded properly according to codes set forth in the National Electric Code (NEC) in order to be covered. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. THE MAXIMUM AMOUNT OF COVERAGE FOR DAMAGE TO PROPERLY CONNECTED EQUIPMENT IS $25,000. Nothing in this warranty shall exclude or limit liability for death or personal injury caused by negligence, for fraud or fraudulent misrepresentation or where exclusion or limitation is not permitted by law.
Other Rights. THESE LIMITED WARRANTIES GIVE YOU SPECIFIC LEGAL RIGHTS, AND YOU
MAY ALSO HAVE OTHER RIGHTS. THIS WARRANTY DOES NOT AFFECT YOUR STATUTORY
RIGHTS. THIS WARRANTY EXTENDS ONLY TO YOU, THE ORIGINAL PURCHASER, AND CANNOT
BE TRANSFERRED OR ASSIGNED. If any
provision of these limited warranties is unlawful, void or unenforceable, that
provision shall be deemed severable and shall not affect any remaining
provisions. In case of any inconsistency between the English and other
versions of these limited warranties, the English version shall prevail.
Registration. Please register your Product at www.echogear.com/registration. Failure to register does not affect your warranty rights.
FORMAL WARRANTY CLAIM
How To Make A Claim. In the event damage has occurred to a Legrand product or to connected equipment, you must contact Legrand within thirty (30) days of the date you knew or should have known of the damages. Follow all instructions for making a claim. THIS REQUIREMENT THAT YOU NOTIFY LEGRAND WITHIN THIRTY (30) DAYS AFTER YOU DISCOVER OR SHOULD HAVE DISCOVERED A PRODUCT DEFECT AFFECTS AND LIMITS YOUR WARRANTY RIGHTS.
GENERAL PROVISIONS
Choice of Law/Jurisdiction. These limited warranties and any disputes arising out of or in connection with these limited warranties (“Disputes”) shall be governed by the laws of England and Wales, excluding the Convention for the International Sale of Goods. The courts located in England and Wales shall have exclusive jurisdiction over any Disputes.
TO THE MAXIMUM EXTENT PERMITTED BY LAW THESE LIMITED WARRANTIES ARE IN LIEU OF AND IN PLACE OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES, CONDITIONS AND OTHER TERMS.
Legrand AV Inc. and its affiliated corporations and subsidiaries (collectively, “Legrand”), intend to make this manual accurate and complete. However, Legrand makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Legrand makes no representation of warranty, expressed or implied, regarding the information contained herein. Legrand assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Confuzzled? Call the ECHOGEAR Pros:
“Wanna show off your hard work?
Share a picture of your completed project with #YourGearUpgraded.
Who knows, it might not be as bad as you thought”
©2021 Legrand AV Inc. All rights reserved. ECHOGEAR is a Legrand brand.
ECHOGEAR and the ECHOGEAR logo are registered trademarks of Legrand.
Legrand AV Inc. • 6436 City West Parkway • Eden Prairie, MN 55344 USA