BlackOUT BO-46-1000 Arcade Game Owner’s Manual

: June 8, 2024
: BLACKOUT

Table of Contents

General Remark
Chapter 01 – Preface
Chapter 02 – Unit Features
Chapter 03 – Unit Installation
Chapter 04 – Procedure to refill Prizes
Chapter 05 – Operator Menu, Game Setup
Chapter 06 – Parts
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BO-46-1000 – Blackout Prize
Operation & Service Manual
Prize with IR sensors- Version 1.2
* Read this manual before use

General Remark

If you encounter any difficulties or if you need support on how to update and/ or install your Blackout product, we invite you to contact your local distributor or reach us at support@aagames.com or by calling our support line +1-450-824-1671

Adrenaline Amusements Team
Adrenaline Amusements
1150 Levis, Suite 302
Terrebonne, Qc
Canada
J6W 5S6

Chapter 01 – Preface

Please read this page before preparing your Blackout product for game play.
The following safety instructions apply to all game operators and service personnel. Specific warnings and cautions will be included throughout this manual.
Use the following safety guidelines to help protect the system from potential damage and to ensure your personal safety:

Electronic components in the game cabinet run on 110V AC 60Hz (220V/ 50Hz in most ofEurope, the Middle East and the Far East delivered units).
To help prevent electric shock, plug the system into a properly grounded power source.
These cables are equipped with 3-prong plugs to help ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable. If you must use an extension cable, use a 3-wire cable with properly grounded plugs.
To help protect your system from sudden increases and decreases in electrical power, use a surge suppressor, line conditioner or Uninterruptible Power Supply (UPS).
Be sure nothing rests on the system’s cables and that the cables are not located where they can be stepped on or tripped over.
Keep your system far away from radiators and other heat sources.
Do not block cooling vents.

Precaution for Game Operation
Adrenaline Amusements Inc. assumes no liability for injuries incurred while playing our games.
Operators should be aware that certain health and physical conditions may make people susceptible to injury when playing video games.

Safety
To avoid electrical shock, unplug the cabinet before performing installation or service procedures.
If a power cord is damaged, it must be replaced by the equivalent power cord available from your distributor.
Adrenaline Amusement Inc. assumes no liability for any damages or injuries incurred while setting up or servicing the cabinet. Only qualified service personnel should perform installation or service procedures.

Environmental Conditions
Cabinet is intended for indoor use only. Be sure to keep the cabinet dry and maintain operating temperatures of 59° – 86° (15° – 30°C).

Chapter 02 – Unit Features

Hardware Features

Multitouch Screen
46’’ transparent Monitor
Windows based computer
12 Prize dispensers
InfraRed Sensors

Cabinet Facts
Cabinet Dimensions

Length = 30’’
Depth = 32’’
Height = 86’’
Weight = 450 lbs

Shipping Dimensions

Length = 30’’
Depth = 36’’
Height = 80’’
Weight = 450 lbs.

Voltage

Voltage	Operating
110V AC	4 AMP
220V AC	2 AMP

Chapter 03 – Unit Installation

Assembling your Blackout Unit

Carefully remove the Cabinet from the shipping container, giving yourself enough space.
Move the cabinet to the desired location.
Lift the top Header to upright position. To do so you will need to press on the spring pins on each side of the hinge.
Plug in the power cord on the back of the cabinet.

Chapter 04 – Procedure to refill Prizes

Very important to perform step 6 and 7
1. Unlock and open front door.
2. Unscrew the pin in the middle of the prize dispenser.
3. Install prizes on dispenser.
4. Re-install the middle pin to secure the prize in the unit
5. Lock the front door.
6. Access the operator menu using the Operator Button located inside the coin door.
7. Enable all dispensers Loaded by pressing the prize dispenser icon (number 1 to 12). The icon is yellow when enabled and grey when disabled. (see figure 5.1 below).
8. Only the prize dispenser in yellow will be available to players if they win.
9. You can test the sensor using rotor #5. (See figure 5.3 below).
10. Press icon “return to Game” when finished.

Refilling Prize Dispensers Steps

1. Unscrew and pull out the prize Rod	2. Hang the Prize on the Spiral
3 Insert&Screw the Prize Rod	4. The Prize Dispenser is refilled

*NOTE: PLEASE DO NOT HANG THE PRIZE ON THE ROD

This chapter describes how to use and navigate the Operator Menu to set up your product and adjust all of the game’s parameters. To access the operator Menu, use the Operator Button located inside the coin door. To navigate the menu, you can touch the arrows to change the option’s value.

Operator Menu	What it does
Credits per Games	Number of credits needed to start a game
Game Volume	Game sound volume
Attract Mode Volume	Attract Mode Volume
Payment type	Display ‘Swipe card’ instead of ‘Insert credits’ in the game
Enable Dispensers	Each number represents a prize dispenser inside the

cabinet. The prize dispenser needs to be enabled to allow the winner to select this prize slot. Yellow enable/grey Disabled.
Return to game| Press to exit the operator menu and return to the game
Payout setting| Press to access the payout setting page (see figure 5.2)
Manage Dispenser| Press to access the manage dispenser page (see figure 5.3)
Stats| Press to access the stats page (see figure 5.4)
Exit to Windows| Press to close the game and go to windows

Payout Settings	What it does
Average payout Minor	Payout adjustable from 1/5 to 1/2500.
Average payout Major	Payout adjustable from 1/25 to 1/2500.
Back	Press to return to the operator menu

Manage dispensers	What it does
Number 1 to 12	Press on the number to select which prize dispenser is minor

or Major
Test| Press to activate a prize dispenser to test if the mechanism is working adequately
Test IR #5| This will enable rotor #5 and will stop turning when the prize fall in the chute
Back| Press to return to the operator menu

Stats Menu	What it does
Total Games	Number of game plays
Total credits	Number of credits inserted in the unit.
Minor prize wins	Minor prizes dispensed
Major prize wins	Major prizes dispensed
Avg. % per game	Average score obtained by the player.
Date last reset	Date of the last manual reset of the stats
Result xx% – xx%	Number of games ended in that % range
Back	Press to return to the operator menu
Logs	View Prize dispensers date/time logs
Reset stats	Press to reset the stats
Clear Logs	Press to reset the Dispensers logs

Chapter 06 – Parts

Ref	Part Description	Part Number
1	Header	INV-09-1004
2	Dispenser	INV-14-0005
3	Prize Chute	INV-07-1010
4	Prize Door	INV-01-0000
5	Caster	INV-62805K-39
6	Leveling	INV-62805K-39
7	Coin Door	ADR-40-3000
8	Speaker&Grill	INV-04-0004
9	Side Glass	INV-07-1020
10	Sensor Kit	INV-25-115-0020

Ref	Part Description	Part Number
1	3 Side Decal Kit	INV-09-1001
2	Door Decal	INV-09-1003
3	Decal Window Right	INV-09-1006
4	Back Decal	INV-09-1008
5	Throw to Win	INV-09-1002
6	Header	INV-09-1004
7	Decal Window Left	INV-09-1007

Screen Assembly INV-01-0001

Ref	Part Description	Part Number
1	Steel Sheet Door.
16GA	INV-01-1020
2	Transparent LCD	INV-00-1300
3	TV Bracket Vertical	INV-01-1010
4	Side Screen Frame	INV-01-1011
5	Top Screen Frame	INV-01-1012
6	Plastic Spacer, Vertical	INV-07-1002
7	Plastic Horizontal Spacer,	INV-07-1001
8	Plastic Spacer, Vertical	INV-07-1003
9	T-Handle Lock	ADR-30-183800
10	LED Strip	INV-14-1006 (07 for Horizontal)
11	Tempered Glass	INV-07-1021
12	Touch Screen Sensor	INV-10-0002

Ref	Part Description	Part Number
1	ADRIO FX + Board	INV-04-1200
2	Computer	INV-11-1001
3	Power Inlet	ADR-05-1241
4	Audio Amplifier	ADR-310-308
5	Power Strip	ADR-05-1240
6	24V Power Supply	ADR-80-1206-00
7	5V-12V Power Supply	ADR-80-0210-00
N	Video AD Board	INV-14-0010