better bathrooms Ashford 800mm Floor-standing Vanity Unit User Manual

: October 30, 2023
: Better Bathrooms

Table of Contents

better bathrooms Ashford 800mm Floor-standing Vanity Unit
OVERVIEW
BATHROOM FURNITURE CUSTOMER CARE GUIDE
Congratulations on your purchase
Important information
Hinge Adjustment
Tools required for installations
INSTALLATION INSTRUCTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

better bathrooms Ashford 800mm Floor-standing Vanity Unit

OVERVIEW

Thank you for choosing Better Bathrooms. Please read this manual before installing your product and keep for future reference.

Multi person assembly
Tools required
We always recommend using professional tradespeople to install your product

BATHROOM FURNITURE CUSTOMER CARE GUIDE

Please note that although these units have been designed to give years of pleasure and satisfaction, you will help maintain the original beauty of your bathroom by following these guide lines.

Melamine, Vinyl and Foil Wrapped Doors
Occasional marks, can in most cases, be removed with a soft damp cloth. More persistent marks can be removed using a non silicone based furniture cleaner. Hot soapy water should be avoided. Once the mark is removed, the area should be wiped over with a damp cloth to remove any excess and dried with a soft clean cloth. On no account should solvent or an abrasive cleaner be used as permanent damage to the finish could take place.

High Gloss Doors
Use a cleaning product not containing aggressive substances like acetone, alcohol, bleach … as those components could seriously damage the surface of the door. The best would be to use a soft cotton or micro fibre cloth with only water and soft soap (containing a maximum 1% of liquid soap)

Carcase Components
Do not use polish on any surfaces. A damp cloth with soapy water will clean off most marks or spills. Bleaches, scouring pads and multi-surface cleaners should not be used.

Drawers, Runners, Door Hinges
These should be wiped out with a damp soapy cloth and wiped dry with a soft cloth as necessary. The roller runners and hinges are lubricated and should not be cleaned with a degreasing agent as this will affect the action of the moving parts. Never lean on partially or fully opened doors and drawers in order to gain access to the units. The hinges are specified to adequately support the weight of the door, plus small additional weights such as wire accessories. It is advised that once the bathroom has been installed you should check every six months that all screws on the hinges are tight.

Worktops
Although the worktop is hard wearing, sharp objects will scratch and excessive heat will scorch the surface. Care should be taken not to drop any heavy objects onto the worktop as the surface may crack. For cleaning, a damp soapy cloth will clean off most spills. Bleaches, scouring pads and multi-surface cleaners should not be used. Corrosive liquids and make-up should be wiped off immeadiately. On no account should any spillage, even water, be allowed to lie on the surface.

Temperature and Humidity
Avoid excessive change in temperature and humidity. Always try to ensure adequate ventilation.

General care, spillages and splashes
On no account should any spillages or splashes, even water, be allowed to lie on any surface. All spillages and splashes should be wiped dry, failure to do so may shorten the life expectancy of the product and invalidate any guarantees.

Congratulations on your purchase

And welcome to our growing gang of savvy shoppers We’re on a mission to bring you extraordinary bathroom products, for less. From modern to traditional style ceramics, plus the gorgeous fixtures, fittings and furniture to match. So, you can fall in love with your space every single day.
As one of the UK’s largest independent bathroom stores, we’ve received countless awards; including the National Business Awards UK, the Digital Entrepreneur Awards and being placed on The Sunday Times Fast Track 100. We hope your new product goes above and beyond your expectations. However, should any problems occur, please:

log in to your account and contact our customer services team via your self-serve portal –betterbathrooms.com/CustomerAccount/Login
contact us via betterbathrooms.com/content/contact-us

Important information

Please read these instructions thoroughly and retain for future reference
Maximum weight limit:
- 80kg (400-600mm cabinet)
- 100kg (600-800mm cabinet)
- 120kg (1200mm cabinet)
- 120kg (tall cabinet)
- 50kg(shelf only)

Please spend 5 minutes reading this section before commencing with the installation of your new furniture.

Should any of your items have a defect, please do NOT install as returns will not be accepted once fitted.
We advise that you use a qualified person to install your units, as any issues relating to poor fitting will not be accepted by the supplier.
You have purchased a handmade and in some cases hand painted product. Therefore, you may see some slight imperfections which the supplier may deem as acceptable.
This product is water resistant but NOT waterproof. On no account should any spillages or splashes, even water, be allowed to lie on any surface. All spillages and splashes should be wiped dry, failure to do so may shorten the life expectancy of the product and invalidate any guarantees.
Please avoid direct sunlight as this will cause the painted surfaces to discolour.
Due to motion in transit, the cabinet doors and drawers may need to be adjusted after installation.
Floor Standing units must be fitted back to the wall through the back rail using suitable fixings. (not supplied)
Basin units should be fitted as above. The basin should also be secured where applicable using Fischer bolts through the fixing points under the basin. (not supplied) Note that not all basins have this facility.
Wall Hung units must be secured back to the wall using the wall-hanging brackets or suitable wall fixings when not supplied. Additional support is recommended using ‘L’ brackets. (not supplied)
When fixing to a stud or paneled wall, the appropriate framework should be installed to support the basins and units.
Where units or worktops have to be cut out for services, all raw edges MUST be sealed against water ingress.

Hinge Adjustment

Drawers Remove/Install
To Remove the Drawer: Follow step ‘A’ and remove the fastener then follow step ‘B’. To Install the Drawer: Follow step ‘B’ and then follow step ‘A’ to lock the fastener. Drawer position: If drawer position needs altering follow step ‘C’ to adjust the screw.

Tools required for installations

The doors / drawers are provided undrilled as the product can be fitted with different length handles, once the door/drawer orientation has been selected, measure the center-to-center hole dimension of the handle to be fitted, and mark this on the outside of the door (double check this as drilled doors cannot be returned) place a block of wood as indicated below on the inside of the door, along with masking tape on the outside where the hole is to be made to prevent chipping and drill through from the front of the door using a 5mm drill bit, do not force the drill and, once drilled apply a small amount of clear silicone in the holes to seal the door”

INSTALLATION INSTRUCTION

Note: For safety reasons Unit must be secured to the wall using suitable fixings (pre-drilled holes provide in back panel of unit)Please note-wall fixings are not supplied These can be purchased from a local DIY store When fitting a basin to a unit, a bead of silicone should be applied to the top edge of the basin unit to seal between the basin and unit. Wall hung unit installation.( fixings in box) Please measure the L distance between each brackets on unit. and H ( height as customers request. The standard height is 850mm (including basin height) from floor to wash basin

Mirror cabinet and Storage unit. ( plug screws with chrome covers in box) Please measure the L&H distance between each pre-drilled holes on products.and fixing them as below steps.the distance will be 300-400 the mirror cabinet to basin as below . the distance from floor to bottom of storage as customer requests.