JENNAIR JBBFX24NHX Bottom Mount Refrigerator Instruction Manual
- June 8, 2024
- JENNAIR
Table of Contents
JBBFX24NHX Bottom Mount Refrigerator
Instruction Manual
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical
shock.
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded electrical supply is
required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a
light bulb, turn the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to OFF and then disconnect the refrigerator from the
electrical source. When you are finished, reconnect the refrigerator to the
electrical source and reset the control (Thermostat, Refrigerator or Freezer
Control depending on the model) to the desired setting. See “Using the
Controls.”
LOCATION REQUIREMENTS
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
Floor must support the refrigerator weight, more than 600 lbs (272 kg), door
panels, and contents of the refrigerator.
Each refrigerator needs to be installed in a separate cabinet frame.
NOTE: This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 13°C (55°F) to a maximum of 43°C (110°F).
The preferred room temperature range for optimum performance, which reduces
electricity usage and provides superior cooling, is between 15°C (60°F) and
32°C (90°F). It is recommended that you do not install the refrigerator near
a heat source, such as an oven or radiator.
OPENING DIMENSIONS
This refrigerator is designed to be installed inside a frame that ts between
kitchen cabinets. The inside of the frame should be a minimum of 69 15/16″
(1776 mm) high, 221 /16″ (560 mm) wide, and 21 7/8″ (555 mm) deep (front to
back). For proper ventilation, you must allow adequate unobstructed space
behind the refrigerator and below and above the frame. Air enters below the
refrigerator and exits above it.
Allow a clearance minimum of 2″ (50 mm) at the top of the frame.
The minimum depth of the base of the frame is 207 /16″ (520 mm) (front to
back).
The base can be as desired, but height should match height of toe kick of
surrounding cabinets. A vent with an opening of at least 31 sq in. (200 sq.
cm) is required for proper ventilation.
If the space between the top of the frame and the ceiling is open air, allow a
minimum of 77 /8″ (200 mm) above the refrigerator.
If the space between the top of the frame and the ceiling is enclosed as part
of the surrounding cabinetry, a vent with an opening of at least 31 sq. in.
(200 sq. cm) is required.
The bottom of the vent must be a minimum of 7 7/8″ (200 mm) above the
refrigerator.
NOTE: Vent covers are not supplied with the unit.
Dimension Table
A| 6915/16″ (1776 mm)
B| 221/16″ (560 mm)
C| Minimum 217/8″ (555 mm)
D| Minimum 207/16″ (520 mm)
E| Minimum 2″ (50 mm)
F| 6911/16″ (1770 mm)
G| 2115/16″ (557 mm)
H| 217/16″ (545 mm)
I| 215/16″ (75 mm)
J| 13/32″ (28 mm)
K| 4011/32″ (1024.5 mm)
L| 25/32″ (20 mm)
M| 27/16″ (703.5 mm)
N| 27″ (685.5 mm)
O| 5/16″ (8 mm)
PRODUCT DIMENSIONS
The unit is 69 11 /16″ (1770 mm) high, 21 15 /16″ (557 mm) wide, and 21 7 /16″
(545 mm) deep (front-to-back). The refrigerator door (including hinges [x2])
is 40 11 /32″ (1024.5 mm) high. The freezer door (including hinges [x2]) is
27″ (685.5 mm) high. The space between the refrigerator and freezer doors is 2
15 /16″ (75 mm). The space between the door hinges is 25/32″ (20 mm).
A grounded 3 prong electrical outlet should be placed within 4″ (101 mm) of
the right side cabinets or end panel. See “Electrical Requirements” for
additional information.
Door Panels Requirements (each door)
Max Weight: 26.5 lbs (12 Kg) Minimum Panels Dimensions:
Refrigerator Door Panel: 42 1⁄8″ (1071.5 mm) x 23¼” (590 mm) x3/4″ (20
mm)Freezer Door Panel: 275⁄8″ (701.5 mm) x 23¼” (590 mm) x 3/4″ (20 mm).
For maximum dimensions, please review the following diagram.
Cabinet frame wall thickness 16 mm
min. R1 [mm]| B [mm]
594| 593| 592| 591| 590
A [mm]| 16| 0| 0| 0| 0| 0
17| 0| 0| 0| 0| 0
18| 0| 0| 0| 0| 0
19| 0| 0| 0| 0| 0
20| 0| 0| 0| 0| 0
21| 0.4| 0| 0| 0| 0
22| 2.6| 2| 1.3| 0.7| 0
23| 5| 4.4| 3.8| 3.2| 2.6
24| 7.5| 7| 6.5| 6| 5.5
How to read this diagram:
For example if the door panel width dimension “B” is 593 mm and thickness of
door panel dimension “A” is 22 mm that means that door panel require radius
“R1” min 2 mm.
Because Whirlpool Corporation policy includes a continuous commitment to
improve our products, we reserve the right to change materials and
specifications without notice.
Dimensions are for planning purposes only. For complete details, see Owner’s
Manual packed with product. Specifications subject to change without notice.
W11602961B
®/™ ©2022 JennAir. All rights reserved.
Tous droits.
Todos los derechos reservados.
Documents / Resources
|
JENNAIR JBBFX24NHX Bottom Mount
Refrigerator
[pdf] Instruction Manual
JBBFX24NHX Bottom Mount Refrigerator, JBBFX24NHX, Bottom Mount Refrigerator,
Mount Refrigerator, Refrigerator
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>