rocketfish RF-HTS120W22 2 Outlet In Wall Surge Protector User Guide

rocketfish RF-HTS120W22 2 Outlet In Wall Surge Protector

PACKAGE CONTENTS

• 2-outlet in-wall surge protector
• White decora-style wall plate
• Screws: 2 long and 2 short
• Quick Setup Guide

Before using your new product, please read these instructions to prevent any damage.

FEATURES

• Replaces a standard duplex outlet
• Status LED lets you know your devices are protected
• Tamper-resistant outlets for added safety
• Provides two standard 125V power outlets
• 1,080 joules of surge protection
• Works in nearly all installations
• Compatible with your existing decora wall plate

We recommend that you use a professional electrician to install the in-wall surge protector.

SAFETY

Warnings:

• RISK OF ELECTRIC SHOCK — Use only in dry locations and only indoors.
• All cables should be routed away from the outlet openings.
• DO NOT use with any aquarium equipment.
• DO NOT install in an outlet that is not grounded.

Notes to the installer:

• This device must be installed in accordance with National and Local electrical codes.
• To prevent severe shock or electrocution, always turn power OFF at the service panel before working with wiring.
• This device should be used with copper or copper-clad wire. DO NOT use with aluminum wire.
• DO NOT plug this device into a shallow wall box. The wall box must be deep enough to house the surge protector. If the box is too shallow, the surge protector. will not fit securely into the wall.

INSTALLING THE SURGE PROTECTOR

Warning: DISCONNECT POWER. Failure to do so can result in severe injury or death.

1. Make sure that you disconnect power to the circuit by removing the fuse from the circuit or turning OFF the circuit breaker.

2. Remove the wall plate and mounting screws that cover the old outlet.

3. Carefully remove the existing outlet from the wall box.

4. Disconnect the wiring from the old outlet.

5. Connect the wires to the surge protector:

   • Black lead attaches to the hot wire

   • White lead attaches to the neutral wire

   • Green lead attaches to the ground wire
     You can attach the wires by:

   • Inserting straight wires into the holes.

   • Tighten every screw and make sure that no bare copper wire is exposed.

6. Carefully insert the surge protector into the wall box.

7. Secure the surge protector to the wall box with the two long screws (provided).

8. Secure the wall plate to the surge protector with the two short screws (provided).

9. Restore power by replacing the fuse or turning on the circuit breaker. The surge protector is ready to use.

USING THE SURGE PROTECTOR
To power electrical devices (like lamps or laptop), plug them into the electrical outlets.

LED INDICATOR

• Blue: surge protected
• Red: wiring fault
• LED off: not surge protected

Note: Only applicable if the outlet is receiving power. The LED is not lit when power is shut off to the outlet.

SPECIFICATIONS

Dimensions (H × W × D)

• With plate:
  4.7 × 3 × 1.9 in. (120 × 76 × 47.6 mm)

• Without plate:
  4.2 × 1.7 × 1.9 in (106 × 44 × 47.6 mm)

Electrical

• Receptacle rating: 15 Amp, 125VAC
• Line voltage: 125V A C @ 60Hz
• Surge protection: 3 lines (L-N / L-G / N-G)
• Clamping voltage: L-N / L-G / N-G = 500 V
• Maximum surge current: 45,000 amps
• Maximum energy dissipation: 1,080 joules
• Wire terminals: #14-#12 AWG UL-1449 certified

LEGAL NOTICES

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

ICES-003
This Class B digital apparatus complies with Canadian ICES-003.

ONE-YEAR LIMITED WARRANTY
Visit www.rocketfishproducts.com for details.
CONTACT ROCKETFISH:
For customer service please call 1-800-620-2790
www.rocketfishproducts.com
ROCKETFISH is a trademark of Best Buy and its affiliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2022 Best Buy. All rights reserved.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>