rocketfish RF-HTMF19 32-Inch to 55-Inch TV Wall Mount Installation Guide

: June 3, 2024
: RocketFish

Table of Contents

RF-HTMF19 32-Inch to 55-Inch TV Wall Mount
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RF-HTMF19 32-Inch to 55-Inch TV Wall Mount
Installation Guide

RF-HTMF19 32-Inch to 55-Inch TV Wall Mount

Tools needed rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall
Mount

Tools for wood stud wall: rocketfish RF HTMF19 32 Inch to 55 Inch TV
Wall Mount - fig 1

Tools for concrete wall:

rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall Mount -
fig

Option 1: Wood stud wall

Locate the stud, then verify the center of the stud with an edge-to-edge stud finder or an awl.
CAUTION: Drywall covering the wall must not exceed 5/8 in. (1.6 cm).
Minimum wood stud size: nominal 2 × 4 in. (5.1 × 10.2 cm) actual 1 1/2 × 3 1/2 in.
(3.8 × 8.9 cm). rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall Mount - fig
3

Align the center of the mounting template at the height you determined and make sure that it is level. Tape the mounting template to the wall.
Drill two pilot holes through the mounting template to a depth of 2 3/4 in.
(70 mm) using a 7/32 in. (5.5 mm) diameter drill bit, then remove the mounting template.

Move the wall plate cover out away from the arm assembly wall plate.

Align the TV arm assembly with the pilot holes, insert the lag screws through washers and into the holes in the wall plate, then tighten the lag screws only until they are firm against the wall plate.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag screws. rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall Mount - fig
6

Align the center of the mounting template at the height you determined and make sure that it is level. Tape the mounting template to the wall, then drill pilot holes to a depth of 3 in. (76 mm) using a 3/8 in. (10 mm) diameter masonry drill bit, then remove the mounting template.
Note: Mount the TV arm assembly directly onto the concrete surface (no wall covering).
Minimum solid concrete thickness: 8 in. (20.3 cm).
Minimum concrete block size: 8 × 8 × 16 in. (20.3 × 20.3 × 40.6 cm).

Insert the concrete wall anchors (see page 8 of the User Guide for ordering information) into the pilot holes and use a hammer to make sure that the anchors are flush with the concrete surface. rocketfish RF HTMF19 32 Inch to
55 Inch TV Wall Mount - fig 8

Move the wall plate cover out away from the arm assembly wall plate. rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall Mount - fig
9

Align the TV arm assembly with the anchors, insert the lag screws through the washers and into the holes in the wall plate, then tighten the lag screws only until they are firm against the wall plate.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag screws. rocketfish RF HTMF19 32 Inch to 55 Inch TV Wall Mount - fig
10

Before using your new product, please read these instructions to prevent any damage.
Warning: Improper installation can result in serious personal injury or TV damage. If necessary, seek the assistance of a professional.