rocketfish RF-HTLF23 Full Motion TV Wall Mount Instruction Manual
- May 15, 2024
- RocketFish
Table of Contents
rocketfish RF-HTLF23 Full Motion TV Wall Mount
Product Information
Specifications
- Compatible with RF-HTLF23(-MX) model
- Tools Needed: 7/32 (5.5 mm) wood drill bit, 3/8 (10 mm) masonry drill bit
- Wall Anchors: 5/16 in. Washers, Wall anchors for concrete only
- Drill Hole Depth: 2 3/4 in. (7 cm)
Product Usage Instructions
Locating Stud and Wall Anchors Installation:
- Locate the center of a stud using a stud finder.
- Drill holes through the template at a depth of 2 3/4 in. using the appropriate drill bit.
- Remove the template and align the wall plate with the holes.
- Insert lag bolts and washers through the holes and gently tighten them.
Installation on Solid Concrete or Concrete Block Wall:
- Align the template at the desired height and ensure it is level.
- Tape the template to the wall securely.
- Drill holes through the template following the specified depth.
- Insert lag bolts and washers through the wall plate holes and tighten gently.
FAQ
-
Q: What type of drill bits are required for installation?
A: You will need a 7/32 (5.5 mm) wood drill bit and a 3/8 (10 mm) masonry drill bit for installation. -
Q: How deep should the holes be drilled into the wall?
A: Drill holes to a depth of 2 3/4 in. (7 cm) as specified in the instructions.
TOOLS NEEDED
OPTION 1: WOOD STUD WALL
- Locate the center of a stud with a stud finder.
- Align the center of the template at the height you determined in Step 5 in the User Guide. Make sure that it is level, then tape it to the wall. Note: Drill into the center holes only.
- Drill holes through the template 2 3/4 in. deep (7 cm) using a drill bit, then remove the template.
- Align the wall plate with the holes, then insert the lag bolts and washers through the holes in the wall plate. Gently tighten the lag bolts.
OPTION 2: SOLID CONCRETE OR CONCRETE BLOCK WALL
- Align the center of the template at the height you determined in Step 5 in the User Guide. Make sure that it is level, then tape it to the wall.
- Drill holes through the template 3 in. deep (7.6 cm) using a drill bit, then remove the template. Note: Never drill into the mortar between blocks.
- Insert the wall anchors into the holes and use a hammer to make sure that the anchors are flush with the surface.
- Align the wall plate with the holes, then insert the lag bolts and washers through the holes in the wall plate. Gently tighten the lag bolts.
Minimum wood stud size:
-
Nominal 2 x 4 in. (5.1 x 10.2 cm) actual 1 ½ x 3 ½ in. (3.8 x 8.9 cm)
-
Minimum horizontal space between fasteners: 16 in. (40.6 cm)
-
Minimum solid concrete thickness: 8 in. (20.3 cm)
-
Minimum concrete block size: 8 x 8 x 16 in. (20.3 x 20.3 x 40.6 cm)
-
Minimum horizontal space between fasteners: 16 in. (40.6 cm)
Wall mount template
Warning: Incorrect installation can result in serious injury or damage to your television. If necessary, seek the assistance of a professional.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>