AMERICAN LIGHTING SPKPL-BRD4-RGBTW-WH Spektrum+ Brio LED Down Light Instruction Manual

AMERICAN LIGHTING SPKPL-BRD4-RGBTW-WH Spektrum+ Brio LED Down Light

INSTALLATION INSTRUCTIONS

SPKPL-BRD4-RGBTW-WH & SPKPL-BRD6-RGBTW-WH
WARNING These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance with these instructions, current electrical codes, and/or the current National Electric Code (NEC).
WARNING The electrical rating of this product is 120V AC. The installer must determine whether power supply is appropriate at the luminaire before installation. Ensure power supply is turned off at the fuse box or circuit breaker prior to attempting installation or servicing of the fixture.
WARNING Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.

SAFETY INFORMATION

• Read all instructions before beginning. Save these instructions for future use.
• To reduce the risk of fire, electric shock, or injury to persons, pay close attention to this manual and stay within its guidelines when using this product.
• Installation of this fixture requires knowledge of recessed lighting luminaires and their electrical systems. If not qualified or uncertain, do not attempt installation. Contact a qualified electrician.
• This retrofit kit is accepted as a component of a luminaire where the suitability of the combinations shall be determined by authorities having jurisdiction.
• This product consumes a maximum 0.15A and operates on a 120V AC, 50/60Hz circuit.
• Supply conductors (power wiring) connecting the fixture must be rated for a minimum of 90°C (194°F).
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• To avoid electrical shock, do not turn on fixture with missing or damaged lens.
• This downlight is suitable for use in wet locations.
• There are no serviceable parts inside of the LED module.
• This fixture is not intended for use with a standard wall plate dimmer switch. Use only with Spektrum+ Smart Lighting Bluetooth App or Spektrumt handheld remote controller (SPKPL-CTRL-W-RGBTW sold separately)

PRE-INSTALLATION

1. Turn power OFF from the electrical panel before starting installation.
2. Locate a suitable location for the fixture and trace the outline of the cut-out template on the drywall or ceiling tile (for a suspended T-Bar type ceiling). Cut the hole following the outline. If needed, refer to Hole Cut Sizes Table for appropriate size.
3. Run electrical wire from the switch (power supply) through the mounting hole; use NMD9O Romex or BX cable.
   For new-construction installation: Brio rough-in plates are recommended.
   For remodel installation; No rough-in plate or can is required, see DRIVER WIRING below.

INSTALLING NEW-CONSTRUCTION ROUGH-IN PLATE

1. Position rough-in plate acroSs two joists and secure it in tour places using its mounting slots and appropriate tasteners.

DRIVER WIRING (See Figures 1-2):

1. Open the hardwire box swing cover and remove the appropriate knockout(s).
2. Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately).
3. Using quick connector, connect green/ground wire of cable to green wire in junction box, connect white wire of cable to white wire in junction box, connect black wire of cable to black wire of box (See Figure 1).
4. Place all wiring and connections back in to the box and close the cover. S. Insert hardwire box through the mounting hole (see Figure 2).

FIXTURE INSTALLATON (See Figures 3-4):

1. Connect the fixture to the hardwire box by inseting and twisting the male/female connectors together (See Figure 3).
2. Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled filush to the celing (See Figure 4).
3. Once assembly is complete, turn on power to confirm fixture is working properly.

CONTROLLING THE FIXTURE

The attached LED controller/receiver utilizes Bluetooth Wireless Technology and can be controlled via the Spektrum+ Smart Lighting App and/or the Spektrum+ Smart Switch (SPKPL-CTRL-W-RGBTW – sold separately). It is not intended to be used with a standard dimmer switch.
DISTANCE OF CONTROL CAPABILITY: 25 meters (approx. 8oft) RESET THE DEVICE: Power the device ON and OFF 3 times in succession. The device will pulse BLUE once reset.
USING THE SPEKTRUM+ SMART LIGHTING APP: Please follow the Spektrum+ Smart Lighting App guide.

CARE AND MAINTENANCE

1. Use only a mild soap and water with soft cloth to clean the fixture. Harsh chemicals will damage the finish.
2. Do not wipe the fixture with a rough cloth that may scratch the finish or the lens.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: .

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, t not instaled and used in accordance with the instructions, may cause harmtul intererence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna. ncrease the separation between the equipment and the recerver Consult the dealer or an eyneriancad rain C tne receiver is connected. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. R EXposure statement The distance between user and products should be no less than 20cm.)

5-YEAR LIMITED PRODUCT WARRANTY

This product is warranted to be free from defects in material and workmanship for a period of five (5) years from the date of purchase. Products that prove to be defective during this period will be either repaired (i.e. replacement of defective electronics, defective parts of the fixture housing, lens, wiring, switching or lamp sockets; excluding the lamp) or replaced, at the discre- tion of American Lighting. Inc claims for defective products must be submitted to the retail location from which the product was purchased withing the warranty period. Upon submission of proper return claim documentation and product to American Lighting, Inc by the retailler, American Lighting, Inc reserves the right to inspect the product for misuse or abuse. Claims for indirect or consequential damages or tor product that, in American Lighting., Incs opinion has bee misused, will be denied. This is a warranty of product rellability only and not a warranty of merchantability or Titness for a particular purpose. Amernican Lignting. Inc shall have no liability whatsoever in any event tor payment of incidental or consequential damages, including. without linmitations, installation costs and damages tor personal injury and property. Ihese products may represent a possible shock or tire hazard t improperly installed or altered in any way. 1his warranty applied only to product that has been properly installed in accordance with instruction sheet and current local codes and/or the National Electrical Code. warranty does not appiy tO any product tnat nas Deen impropery instaled or in siuauon wnere components nave Deen direred ln dny way. nis warrany: (9 exciudes expendabie pats inciuaing Dut not imited to lgnt buibs, batteries; (2) carries a 2-year tinish warranty protecting tinish against tarnishing, flaking, and discolorations, and (5) does not cover any lo55es, labor, injuries to persons property or costs. Ihis warranty does give you specitic legal rights and you may have other rights, which vary from state to state, Be careful, it is recommended that installation be done by a qualified professional; the purchaser has sole responsibility for proper installation in compliance with all state and local code requirements. Seller’s employees are not qualified to advise you on the use of this Merchandise. Any oral representationls) made will not be binding on seller or its employees. The rights under this limited warranty are to the original purchaser of the Merchandise and may not be transferred to any subsequent owner. This limited warranty Is in lieu of all warranties, expressed or implied including warranties or merchantability and fitness Tor a particular purpose. Seller shall not be liable tor any special, incidental, or consequential damages. Ihe sold exclusive remedy against the seller will be tor the replacement of any derects as provided herein, as long as the seller is Willing or able to replace this product or is wiling to retund the purchase price as provided above.
For questions/comments, technical assistance, or repair parts- Please call toll free at 1-800-285-8051 (M-F 8am- 5pm), cST)
2022 American Lighting, Inc. REV2209 www.AmericanLighting.com
11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>