K nner S hnen KS6100HDE Heavy Duty Diesel Generator Instruction Manual

June 8, 2024
K nner S hnen

K nner S hnen KS6100HDE Heavy Duty Diesel Generator Instruction Manual
K  nner   S  hnen KS6100HDE Heavy Duty Diesel
Generator

Introduction

Please read the operating manual carefully before getting started!

Before the first start, fill the crankcase with engine oil.

To do this, proceed as follows:

  1. Unscrew the oil dipstick.
  2. Use a funnel to fill the crankcase with engine oil (SAE 10W-30, SAE 10W-40).
  3. The oil level should be equal to the level in the filler neck.
    Using Instruction
Check the oil level in the crankcase.

To do this, proceed as follows:

  1. Insert the dipstick without screwing it in.
  2. Check the oil level by a mark on the oil dipstick. It must be between the MIN and MAX marks.
  3. Add fresh oil if its level is below the lower mark.
  4. Tighten the oil dipstick.
    Using Instruction
Fill the fuel tank with diesel fuel.
  • Check the fuel level on the fuel level sensor.
  • Tighten the fuel cap securely.
  • The type of diesel fuel must comply with the operating season.
    Using Instruction

Connect the terminals to the battery ensuring the correct polarity (“plus” to “plus”, “minus” to “minus”).
Using Instruction

Set the emergency engine switch to START (ON).
Using Instruction

During the first start-up, be sure to bleed air from the fuel system.

To do this, proceed as follows:

  1. Remove the protective rubber plug on the top of the generator.
    Using Instruction

  2. Hold down the compression release lever.
    Using Instruction

  3. Turn the start key to the “START” position and hold it in this position for several seconds.

  4. After 2-3 seconds, release the compression release lever without releasing the start key.

  5. After the engine starts, release the start key for it to return to the “ON” position.
    Using Instruction

After starting the generator, wait 1-2 minutes before connecting the load.
Then turn the safety switch on the generator panel to the “ON” position.
Using Instruction

To start the generator in winter, turn the start key to the “START” position by holding the “HEAT” heating button on the generator panel.
Using Instruction

CUSTOMER SUPPORT

If the engine does not start, repeat steps 1-5 in two to three minutes (see pages 7-9).
If the engine does not start after three successive attempts, contact our after-sales and service support.

Germany: DIMAX Int. GmbH,
An Sankt Germanus 13, 50389,
Wesseling

Logo.png

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

K nner S hnen User Manuals

Related Manuals