VATION LIGHTING ATL002 12 Pack 6 Inch 5CCT Ultra Thin Dimmable LED Recessed Light Installation Guide
- June 15, 2024
- VATION LIGHTING
Table of Contents
VATION LIGHTING ATL002 12 Pack 6 Inch 5CCT Ultra Thin Dimmable LED Recessed Light
INSTALLATION STEPS
(Step 1)
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
- Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
(Step 2)
- Open the hardwire box swing cover and remove the appropriate knockout (s)
- Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately) .
- Using wire nuts, connect green ground wire of cable to green wire on box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box. (Fig.2)
- Place all wiring and connections back in to the box and close the cover.
(Step 3)
- Insert hardwire box through the mounting hole.
New construction applications:
Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
Remodel applications: Do not require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.
(Step 4)
- Connect the fixture to the hardwire box by inserting and twisting the male/female connectors.
(Step 5)
- Push spring loaded clips on the fixture upwards and insert fixture base in to the mounting hole. Release the clips and fixture will be pulled flush to the ceiling.
- Once assembly is complete, turn on power to confirm fixture is working properly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>