peerless-AV TVFT665 TruVue Universal Flat Tilt Wall Mount Installation Guide
- June 9, 2024
- Peerless-AV
Table of Contents
peerless-AV TVFT665 TruVue Universal Flat Tilt Wall Mount
tools
WARNING
This product is designed to be installed on wood stud or solid concrete walls. Hardware is included for wood stud and solid concrete installation. Before installing make sure the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Be careful not to pinch fingers when operating the mount. For support please call customer care at 905-503-7733
Tools Needed for Assembly
To properly tighten
screws: Tighten until screw head makes contact, then tighten another 1/2 turn.
Do not overtighten screws
WARNING
When installing Peerless wall mounts on a wood stud wall covered with gypsum
board (drywall), verify that the wood studs are a minimum of 2″ x 4″ nominal
size. Do not install over gypsum board thicker than 3/8″.
Level wallplate. Mark mounting holes.
Center adaptor brackets vertically on back of screen.
Use of spacers and washers is optional
Warranty
Peerless-AV Europe
Unit 3 Watford Interchange,
Colonial Way, Watford, Herts,
WD24 4WP, United Kingdom
Customer Care
44 (0) 1923 200 100
www.peerless-av.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>