peerless-AV TVFT650 TV Wall Mount Installation Guide
- June 9, 2024
- Peerless-AV
Table of Contents
Installation Guide
TVFT650 TV Wall Mount
Parts List
| Description| Qty
---|---|---
A| wall plate| 1
B| adaptor bracket| 2
C| bubble level| 1
D| M6 concrete anchor| 4
E| M6 x 60mm wood screw| 4
F| M4 x 12mm| 4
G| M4 X 25mm| 4
H| M6 x 12mm| 4
I| M6 x 25mm| 4
J| M8 x 12mm| 4
K| M8 x 25mm| 4
L| M8 x 50mm| 4
M| M6 washer| 8
N| M8 washer| 8
O| spacer| 4
P| M8 x 35mm| 4
|
---|---
**WARNING
This product is designed to be installed on wood stud or solid concrete walls.
Hardware is included for wood stud and solid concrete installation. Before
installing make sure the supporting surface will support the combined load of
the equipment and hardware. Screws must be tightly secured. Do not overtighten
screws or damage can occur and product may fail. Never exceed the Maximum Load
Capacity. Always use an assistant or mechanical lifting equipment to safely
lift and position equipment. This product is intended for indoor use only. Use
of this product outdoors could lead to product failure or personal injury. Be
careful not to pinch fingers when operating the mount. For support please call
customer care at 905-503-7733.
Symbols
WARNING**
Tools Needed for Assembly.
** To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2 turn. Do not overtighten screws.
1a
WARNING When installing Peerless wall mounts on a wood stud wall
covered with gypsum board (drywall), verify that the wood studs are a minimum
of 2″ x 4″ nominal size. Do not install over gypsum board thicker than
3/8″.
1a-2
Level wallplate. Mark mounting holes on stud center lines. 1a-3 Drill
mounting holes into supporting surface (2.5″ (64mm) minimum depth required).
1a-4
Level wallplate. Install using wood screws provided. 1b
****WARNING When installing Peerless wall mounts on a concrete wall,
the wall must be at least 8″ thick with a minimum compressive strength of 2000
psi. Never attach concrete expansion anchors to concrete covered with plaster,
drywall or other finishing material.
1b-1 1b-2 Drill mounting holes into supporting surface (2.5″ (64mm)
minimum depth required). 2 Center adaptor brackets vertically on back of
screen. 3 Use of spacers and washers is optional. 7 Optional: Remove display
Model #: TVFT650
Part #: TVTM, TVFT4X4, TVFT650-XXX, IQMT443250, T4X4, HFT640, EFT320, TRFT640,
TRWS2210/BK
This page intentionally left blank.
Warranty
**www.peerless-av.com/warranty
Peerless-AV
2300 White Oak Circle
Aurora, IL 60502
Email: [email protected]
Ph: 800-865-2112
Fax: 800-359-6500
www.peerless-av.com
© 2020, Peerless Industries, Inc.
Peerless-AV Europe
Unit 3 Watford Interchange,
Colonial Way, Watford, Herts,
WD24 4WP, United Kingdom
Customer Care
44 (0) 1923 200 100
www.peerless-av.com
© 2020, Peerless Industries, Inc.