SINOTRACK JET01 Portable GPS Locator User Manual

SINOTRACK JET01 Portable GPS Locator

Appearance schematic diagram

Install the SIM card

Selects the SIM card size

Please buy a standard Micro SIM card (recommended not to cut the card )

Install SIM card

Open the soft glue plug (open in the USB icon position), and insert the SIM card in the correct direction, as shown in the figure below

Charge the equipment

When the charger is connected, the red light of the device will often illuminate, which means charging, the green light means full

• If there is no electricity at all, be full for about 2 hours
• Charging is normal to have a micro-heating phenomenon
• The switch machine can be charged
• 5V charge

Powered on and powered off

Starting up
Press the switch button for 3 seconds, see the blue light on (representing power on) to release

Search the Internet
After the boot will need to search the network, when the equipment blue lights will flash (No installed card / invalid card keeps flashing)

Run feedback:
During normal operation, the equipment will illuminate the key blue lights, which is in normal operation
Press the switch if the blue light is not on means that the equipment is out of power, charge

Shut down
Press the switch key for 5 seconds, and the equipment blue light flashes (representative Shutdown down) to release

Mobile phone scan download APP

• Use the mobile phone scan to download the APP software for installation
• Enter the numeric code on the product, Initial password 123456
  Scan the QR code to download the tracking system

Description of the letter function mode

Smart positioning (for emergency continuous updating of location, and power consumption): The device gets the latest location every 30 seconds
Timed positioning (recommended to use, this mode is more power-saving): the equipment can choose 10 minutes / 30 minutes / 1 hour to obtain the latest position
Depth dormancy (very power-saving): The device is always on standby and refreshed through APP to get the latest position
Note: The factory default is the timing positioning mode (10 minutes)

Recording/listening / automatic recording sound recording

Open the APP-one recording-one select duration-one determine one-Wait about 10 minutes to receive the voice monitor
Open the APP-a listen one-enter the listen number and wait about 10 seconds to receive a call  (If the card is a voice card.)

Automatic recording

With this function on, the device will regularly record and upload it (more power consumption and flow consumption)

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>