EMOS 1550010000 Connect Start Unit Power+Chain Instructions
- June 9, 2024
- EMOS
Table of Contents
zdroj: m:INDESIGN_Skupinove navody Vanocemanual_8_connect_START_UNIT_adaptery.indd 105 × 148 mm
LED Connecting System
The “Connecting System” is a system of light chains that can be extended to a maximum of 800 LED. Use only in conjunction with a 30 V DC transformer and light chains from the EMOS system.
“Connecting System”
The light sources are not replaceable.
Do not connect to power supply if the conductor insulation is damaged.
Do not connect the light chain to power supply if it is still in packaging.
Do not interconnect parts of this light chain with parts of light chains made
by a different manufacturer. I.e. the light chain must not be connected to
light chains, transformers or cabling connection systems of other brands.
Connection is done using only the supplied connectors. All open ends must be
sealed before use. I.e. before using the device, check that the end plug
around the socket connector is closed.
In case the connecting cable or the light chain has to be replaced due to
damage, use only cables approved by the manufacturer.
Should the light source rupture or become damaged, do not use the light chain
or leave it connected to the power supply. Instead, dispose of it in a safe,
environment-friendly way.
Not suitable for year-long outdoor use.
WARNING - THIS LIGHT CHAIN MUST NOT BE USED WITHOUT THE APPROPRIATE GASKETS! WARNING RISK OF INJURY BY ELECTRICAL CURRENT! DO NOT USE WITH MISSING OR DAMAGED LIGHT SOURCES!
The product is designed for decorative lighting.
The product is not a toy; do not put it in the hands of children!
Timer (T):
The light chain has a built-in timer on the body of the transformer (adapter). After the first connection, the chain will be constantly lit. After the second connection (a green light will light up), the timer will be set to 6 hours. Afterwards, it turns off automatically and will remain off for 18 hours. The timer will operate automatically in these intervals (6 hours on/18 hours off) until turned off by making a third contact.
Example:
The chain will turn on on 1 December at 18 oclock. It will remain lit until midnight, then turns off automatically. On 2 December, it will turn on automatically at 18 oclock and turn off again at midnight. That means that
the chain only has to be turned on once, and it will automatically keep
lighting in this fashion until you turn it off.
Changing the timer settings:
If you wish to change the time when the chain automatically turns on and off
(e.g. 19 oclock until 1 oclock), all you need to do is turn off the chain at
the desired time (if it is turned on) and then turn it on again.
Note: The timer may deviate by a few minutes per month. If you want to adjust
the turn-on timer back to the original time, set the timer again.
EMOS spol. s r.o. declares that the LED Connecting System is in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed on landfill, dangerous substances may reach groundwater and subsequently food chain, where it could affect human health.
ZNAMKA: LED povezovalni sistem
TIP: ___
Servis: EMOS SI, d.o.o., Rimska cesta 92, 3311 Sempeter v Savinjski dolini,
Slovenija tel: +386 8 205 17 21
e-mail: reklamacije@emos-si.si
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>