OUTWATER Anaglypta Instructions

June 9, 2024
OUTWATER

OUTWATER Anaglypta

OUTWATER-Anaglypta-PRODUCT - Copy

INSTALLATION INSTRUCTIONS FOR ANAGLYPTA

SURFACE PREPARATION

  • Make sure the walls are clean
  • Repair any wall damage before installing
TOOLS REQUIRED
  • Anaglypta wall coverings
  • Utility knife
  • Straightedge razorblade
  • Marker
  • Long-bristled brush
  • Clay-based adhesive
GENERAL APPLICATION FOR WALL COVERINGS
  • With a chalk line, snap the wall where the Anaglypta will be installed.
  • Let the Anaglypta lay out for a few minutes so that it uncoils nicely.
  • Anaglypta may need to be cut at the desired height. Height is normally 32” to 36” up the wall, which is about 1/3 of the wall’s height. It can also be used for wainscoting applications.
  • When ready, roll or brush the adhesive evenly onto the back of the wallpaper.
  • Fold the edges over each other to join them (bookend).
  • Distribute the glue underneath with a long-bristled brush.
  • Use a foam roller to put some pressure on the paper. Do not crush it.
  • Wipe any excess glue away with a damp sponge.
  • Use a chair rail moulding such as our RPS-0298 for a beautiful look.

PAINTING
Use a high quality latex paint. You could use a two-tone style to enhance the appearance of the wall if needed.

Architectural Products by Outwater assumes no liability for improper installation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

OUTWATER User Manuals

Related Manuals