OUTWATER INDUSTRIES ALU 5164-S Aluminum Corner Channel Molding Instructions
- June 9, 2024
- OUTWATER INDUSTRIES
Table of Contents
- OUTWATER INDUSTRIES ALU 5164-S Aluminum Corner Channel Molding
- ALUMINUM OUTSIDE CORNERS CUTTING INSTRUCTIONS
- FOR USE WITH PART#s: ALU5164-S, ALU5299-S, ALU5116-S, ALU5163-S,
- USING THE TABLE SAW FOR 3/4” BOARD
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
OUTWATER INDUSTRIES ALU 5164-S Aluminum Corner Channel Molding
ALUMINUM OUTSIDE CORNERS CUTTING INSTRUCTIONS
FOR USE WITH PART#s: ALU5164-S, ALU5299-S, ALU5116-S, ALU5163-S,
ALU5272-S, ALU5162-S, ALU5165-S
** The CW Systems cutter head set ( Part # CW-TOOLS** ) creates cuts for all of our corner extrusions. For those interested in the CW system, yet not prepared to purchase a cutter head set, there is an alternative, using a table saw.
USING THE TABLE SAW FOR 3/4” BOARD
Before cutting the actual boards, it is recommended that a 3/4” sample board be used for the following steps to ensure adequate fit of the corner.
-
To make the outside cut, set the height of the saw blade to 1-5/16”. Put the finished side of the board towards the fence and shave off 1/16” by adjusting the saw blade
-
To make the inside cut, adjust the blade 3/8” from the fence, with the finish side against the fence. This cut is critical.
Any variance will not allow a proper fit for the extrusion.
Outwater Plastics Industries, inc. assumes no liability for improper installation. -
To make the final cut, set the saw blade at a 45° angle and 1/2” from the fence. Place the exterior of the finished side up and cut. Be cautious of kick back.
NOTE: To use corners on material less than 3/4” thick, simply glue a wood strip or cleat to the panel edge prior to shaping.
24 River Road • Bogota, NJ 07603 • 1.800.631.8375
Outwater Plastics Industries, inc. assumes no liability for improper
installation.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>