FAUCETURE EV4318 Century Vessel Sink Instruction Manual

Table of Contents

FAUCETURE-EV4318-Century-Vessel-Sink-product-image

Remove horizontal leg and slip joint nut from bottle trap.
Apply Teflon tape to all exposed threads.
Insert slip joint nut (3) and waste cover (4) onto horizontal leg (6).
Insert horizontal leg into wall waste opening, do not tighten.
Insert black washer (2) and slip joint nut (1 )onto tail piece (8).
Attach bottle trap (7) to tail piece and hand tighten slip joint nut (1).
Align bottle trap with horizontal leg and tail piece, at this point it may be necessary to cut part of tail piece or part of horizontal leg to obtain proper alignment.
After all components have been properly aligned, insert horizontal leg making sure to insert black washer (5) before tightening slip joint nut (3).
Thread both slip joint nuts onto bottle trap and tighten along with slip joint securing horizontal leg to wall waste opening.
Check for leakage by opening faucet and letting water run for at least 45 seconds

CAUTION
Failure to follow all installation directions may cause product to detach from the wall and cause serious injury

Before Installation :

Prior the installation, unpack your new Kingston Brass product and inspect 1t keep the product in its original package until you are ready to install it.
Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls, including all additional wall supports, maybe required.
Observe all local plumbing and building codes.
Do not install this fixture alone.
Make sure to select appropriate drain as some of Kingston Brass vessel sinks do not include overflow hole

Place basin/sink on top of counter where it will be installed.
Mark the location of drain opening.
Use the installation template to make a cut out on the counter. (If sink does not require a template to cut the counter, sit the basin above the counter)
Mark hole position by measuring the distance from counter height to center of mounting hole and center to center between two back mounting hole
Turn basin/sink over; apply a very thin bead of clear caulking around the base of basin/sink.
Drill two holes, insert the appropriate anchors for your wall type. This basin/sink includes toggle bolt anchors for drywall installation, if your wall is not a drywall type; please consult a professional to specify the appropriate anchors.
Turn right side up and place basin/sink on counter, center basin/sink on cut out, insert and tighten the bolts on the anchors. Clean all excess caulking.
Insert the drain as show in picture, tighten the drain nut from underneath of the counter and making sure not to over tighten as this may cause cracks in your basin/sink

$FAUCETURE-EV4318-Century-Vessel-Sink- $3$$

If you are installing on a plaster (Drywall) wall we recommend using toggle bolt anchors (included), drill a 5/8″ hole at the marked location of the holes
Remove toggle from bolt, insert washer on the bolt and insert bolt through the basin mounting holes.
Thread no more than 1/211 , with the tip of the toggle pointing towards the head of the bolt, apply a bead of silicone caulking around the perimeter of the back of the sink and secure the sink to the wall by inserting the toggle bolt through the holes.
Make sure that the bolt went far enough to allow the toggle bolt to open, thread the bolt while pulling on it, this will ensure that the toggle inside the wall will not spin, thread until the basin has been properly secured.

www.kingstonbrass.com
TOLL-FREE CUSTOMER SERVICE: 1-877-2-KBRASS TECHNICAL SUPPORT
E-mail: service@kingstonbrass.com 12775 Reservoir Street, Chino, CA 91710 © 2020-08-T Kingston Bras.