MIKUSO Mos-w085 2.4Ghz Wireless Mouse User Manual
- June 9, 2024
- MIKUSO
Table of Contents
MIKUSO Mos-w085 2.4Ghz Wireless Mouse
Installation steps
- Plug the USB receiver into the computer USB connector
- Installing the battery Install the keyboard mouse battery correctly according to the identification. At this time, it enters the working state.
- When in use, the keyboard’s red light flashes, please replace the battery: the mouse line is discounted, please replace the battery.
Recode
If the battery cannot be used during use, please confirm whether the battery is correctly installed and has sufficient power, or if there is no response, please follow the following steps to re-code:
- Unplug the USB receiver and product battery first (power off)
- Plug the USB receiver into the computer USB connector.
- Attach the keyboard to the battery
- After confirming that the receiver is plugged in (within five seconds), press and hold ESC+Q (the keyboard automatically aligns and locks the code)
- The mouse does not need code checking
Safety Statement
- Please read the following items before use and keep this statement as the basis for the future
- Do not drop or hit your keyboard&mouse.
- Do not use your keyboard&mouse under strong vibration, because vibration may damage your keyboard&mouse.
- Do not disassemble or modify your keyboard&mouse in any way. Disassembling or refitting your keyboard&mouse will invalidate your warranty, or may cause a short circuit
- Please do not use your keyboard&mouse in a damp environment. If liquid seeps into the keyboard&mouse, it may cause product damage or a short circuit
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirement. The device can be used in portable exposure conditions without restriction