AIGOSTAR 330200ICQ Vacuum Cleaner Instruction Manual

330200ICQ Vacuum Cleaner
Instruction Manual

330200ICQ Vacuum Cleaner

MODEL: 330200ICQ
PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING THIS PRODUCT AND RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

IMPORTANT SAFEGUARDS

1. Before turning your vacuum cleaner on, ensure that the electrical voltage and circuit frequency correspond to that specified on the appliance.

2. To reduce electrocution risk, never operate this product or handle the plug with wet hands, never submerge it under water nor spill liquids into the product.

3. Do not insert any objects into the appliance.

4. If the supply cord is damaged, in order to avoid a hazard it must be replaced by the manufacturer or its service agent or an appropriately qualified person.

5. Regularly check the appliance and cord for visible damage. Do not use if the cord or housing is damaged, if it has been dropped, damaged in some other manner, left outdoors or dropped into water, or if it appears faulty in any way. Call the aftersales support line if any part appears damaged.

6. Do not kink, bend, squash, strain, or damage the power cord.

7. Do not pull or carry the vacuum cleaner by the cord. Do not use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners.

8. Do not run the vacuum cleaner over the cord. Keep the cord away from heated surfaces.

9. Turn off the vacuum cleaner controls before connecting or disconnecting from the mains supply.

10. WARNING: Always switch off and unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories, as well as before emptying or cleaning the dust tank.

11. Do not pull on the cord to disconnect the plug from the power supply. To unplug, grasp the plug, not the cord, and then press the cord retraction button to retract.

12. This appliance is intended for household use only. It is neither suitable for commercial/industrial or for outdoor use.

13. Only use the vacuum cleaner on dry, indoor surfaces, as described in this manual, and with the original accessories supplied by the manufacturer/distributor.

14. Do not use the vacuum cleaner for any other purpose than described in this manual.

15. Improper installation and use may result in the risk of fire, electric shock, and/or injury to persons. We assume no liability for any eventual damages caused by improper or faulty use.

16. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructions on using the appliance by a person responsible for their safety.

17. Young children must be supervised to ensure they do not play with the appliance. Close supervision is necessary when the appliance is used by or near children. Never leave the appliance unattended.

18. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.

19. Keep the end of the hose, tube, and other openings away from your face and body.

20. When in use, do not point the vacuum cleaner at people or animals.

21. Do not use the product without the filters in place.

22. Take extra care when vacuuming on stairs.

23. Do not use the vacuum cleaner to pick up the following: flammable or combustible fluids (such as fuels or solvents), or burning substances (such as ash, cigarettes or hot coals). Also, do not use the vacuum cleaner in the presence of explosive liquids or vapours; hard or sharp objects such as shards of glass, nails or coins; harmful or toxic materials (such as chlorine bleach, ammonia and drain cleaner); or any liquids — plus, avoid vacuuming in areas where liquids may be present.

24. Keep the vacuum cleaner away from heat sources (radiator, oven, etc.), direct sunlight, moisture, and sharp edges.

25. Keep all openings free of dust, lint, hair, or anything that may reduce the airflow.

26. Do not use the product with any openings blocked or with restricted airflow.

27. Put the vacuum cleaner away after each use to prevent anyone from tripping over it.

28. Store the vacuum cleaner indoors in a cool, dry area, out of reach of young children.

29. Never attempt to open the motor base of the vacuum cleaner yourself or to replace the power cord. If the vacuum cleaner is damaged, it must be repaired by the manufacturer, its service agent, or an appropriately qualified person in order to avoid a hazard. In case of damage, call the aftersales support line for advice.

30. Never use this machine when the suction power becomes very weak. If this happens:
    • Switch off the unit, unplug it, then check whether the dust container is full.
    • Following this, then check if any part of the floor brush, tube, or hose is blocked.
    • Do not use the vacuum cleaner until the blockage is removed and the appliance operates normally again.
    If you cannot solve the problem, contact the aftersales support line.

31. Always switch the vacuum cleaner off after use and, before plugging it in again, make sure to hold the appliance firmly during use.

32. Always switch off and unplug the vacuum cleaner from the electrical outlet before assembling, before opening or emptying the dust bag, or before connecting/disconnecting the attachments.

SPECIFICATION

PRODUCT OVERVIEW

1. Handle
2. Front cover button
3. Front cover
4. Suction base
5. Accessories cover
6. Dust full indicator
7. Cord rewinding button
8. Back cover
9. Power cord and plug| 10. Big Wheel
11. Air outlet cover
12. ON/OFF switch
13. Speed minus button
14. Speed add button
15. Accessories storage room
16. Round brush
17. Crevice nozzle
18. Floor brush with release button| 19. Textile dust bag
20. Hose
21. Remote control with Indicator
22. Hose release button
23. High adjustment ring
24. Tube
25. Two AAA 1.5 V batteries
26. Single-use paper dust bag*3
---|---|---

PRODUCT ASSEMBLY AND USE

1. Connect the hose to the dust chamber
   • Insert the hose into the suction base and turn clockwise. To remove the hose, turn the hose anticlockwise and pull it out.
   

2. Connect the hose to the extending tube:
   • Hold the connector of the hose and insert it into the bigger hole of the tube until fixed in place. If you want to disassemble, press the hose release button and pull it out.
   

3. Adjust the tube length:
   • Slightly pull down the length adjustment ring; the tube length can be adjusted to your preference.

4. Connecting the tube and the brush:
   • Push the extending tube into the floor brush hole until it is firmly in place. To remove the floor brush, press the release button on the brush and pull it out.”
   • Operating the brush control pedal: When cleaning hard floors, lower the brush by pushing gently on the tread pedal with one foot. When cleaning carpeted floors, push on the tread pedal again to raise the brush.
   • Operating the suction control slide: When cleaning hard floors, open the suction control slide to reduce resistance. When cleaning carpeted floors, close the slide to generate stronger suction.

5. Use the accessories
   • The accessories can be connected to the tube and hose.
   • Round brush: Used primarily for cleaning desktops and other smooth surface furniture.
   • Crevice nozzle: Mainly used to clean between narrow gaps. The vacuum and suction are significantly enhanced by the narrow aperture.

6. Operating the vacuum cleaner:
   • Insert the plug into the power socket that conforms to the label’ s power supply guidance, then press the on/off switch pedal and the vacuum cleaner will start working.

7. Adjust the vacuum power:
   • Use the symbols on the vacuum power display as a guideline, press the “+” button (increase vacuum power) or the “-” button (reduce the vacuum power).

8. Use the remote control handle
   • Batteries installation for remote control Before using this product, please place the batteries into the compartment of the remote control handle grip. Gently open the battery cover and put two AAA 1.5 V batteries into the compartment of the remote control, then close it.
   Note: Make sure that the battery “+” and “-” do not reverse polarity. When the vacuum cleaner is not being used for a long time, please take out the batteries from the remote control compartment.
   • Connect the remote control handle to the vacuum cleaner:
   Press the vacuum cleaner’ s speed control buttons & ” – ” +” at the same time until the 5 icons on the LEO screen flash together. Pressing any button on the handle will then successfully connect the handle to the cleaner.
   Note: The buttons on the remote control have the same function as those on the vacuum cleaner.
   Note: Only when the vacuum cleaner’ s switch button is on will the remote control take effect.
   Note: If the remote control’ s indicator light doesn’ t light up when pressing any button, replace the battery according to the chapter “Batteries installation of remote control”.

9. Power cable retract
   • When operating the appliance, do not continue to pull the power cable out of the vacuum beyond the yellow mark. If the power cable has been removed to the extent that the red mark is visible, then retract some of the cable. When you have completed the cleaning process, turn off the power, remove the appliance plug from the socket, and press the power cable to retract the button until the cord has been fully retracted back into the machine.

CLEANING AND MAINTENANCE

Caution: The plug must be removed from the power socket before any maintenance or replacement.
CLEAN/REPLACE THE DUST BAG
When the dust full indicator turns red or the cleaner has a loss of suction, it is time to clean the dust bag or replace it with a new bag.

• Open the front cover by touching the front cover button, then take out the dust bag and clean it.
  

• Install the dust bag: Put the dust bag into the bag holder and then insert the paper card into the slot cabinet.

• Only clean the housing with a soft, dry cloth. Do not use liquid or aerosol cleaners.

• IMPORTANT: Wash the filters to improve vacuum performance. Make sure that all filters are completely dry before reattaching them.

• Clean the inlet filter with warm water then allow it to dry fully before placing it back into the unit. Replacing the inlet filter: Clip down the inlet filter and remove the cover, then remove the old filter and replace it with a suitable new filter.
  

• Clean the outlet filter: Open the outlet cover and take out the HEPA frame and filter. Wash the filter then install it only after it has fully dried.
  

TROUBLESHOOTING

2. The power switch hasn’t opened
3. The motor burned out| 1. Re-plug
2. Press the power switch
3. Repair or replace with a new motor usingauthorized people
The suction has become
weak| 1. The suction head channel is blocked
2. Poor ventilation dust bag
3. Air inlet and outlet filter are blocked
4. Motor problems| 1. Clean the suction head channel
2. Clean the dust bag
3. Clean the filter
4. Repair or replace with a new motor by authorized people
A full dust indicator of adverse action| 1. The dust suction channel block
2. The indicator slide is stuck
3. The spring is broken| 1. Clean the dust absorption channel
2. Repair the full dust indicator

STORAGE

When not in use, neatly store the appliance in a cool, dry location away from direct sunlight. To save space, the floor brush can be stored at the back of the appliance.
DISPOSAL
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle the product responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer from whom the product was purchased. The retailer can take this product for environmentally safe recycling.
WARRANTY: TWO YEARS

http://weixin.qq.com/r/NjtQSEjEtBXLrQwr924k
SAMSPARTY SL CL CABANA 78, 45210 YUNCOS ,TOLEDO,ESPANA B45824786
https://WWW.AIGOSTAR.COM
MADE IN P.R.0

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>