Vorago KICK Scooter 302 User Guide

**Vorago KICK Scooter 302 User Guide

**

KNOW YOUR SCOOTER

1. Front Light
2. Brake
3. Folding mechanism
4. Charging port
5. Kick Stand
6. zgine 7 Disc brake 8 Brake light 9 Manual brake
7. Deck
8. Handlebar
9.  Displays
10. Throttle

CAUTION

• Read and understand all product and safety warnings.
• Do not modify the shooter.
• Before each use, check and confirm: That all protectors and pads are in place and in optimal condition; That the brake system works properly; and that the tires are in good condition and with sufficient tread remaining.
• Do not perform races, stunts or other maneuvers that can cause loss of control.
• Do not allow hands, feet, hair, body parts, clothing or similar items to come into contact with moving parts, wheels or powertrain, while the engine is running.
• Obey all local laws and re9ulations on scooter use and traffic.
• Don’t drive at night. Use only in adequate daylight and optimal visibility conditions.
• Do not operate in case of: Heart conditions; Pregnant women; People with head, back or neck ailments, or previous surgeries in those areas of the body; and people with any physical or mental condition.
• Always use safety equipment such as a helmet, knee and elbow pads. Always wear a helmet when riding your scooter and keep the chin strap securely fastened. Always wear tennis shoes.
• Wear appropriate clothing, reflective if possible.
• Avoid sharp shocks, drain grates and sudden surface changes.
• Avoid streets and surfaces with water, sand, gravel, dirt, leaves and other debris. Wet weather affects traction, braking, and visibility.

PERSONAL SECURITY

Driving the scooter without protective equipment, clothing, shoes or a helmet can cause serious injury or death. Always wear gear, clothing and a helmet when wearing your scooter.

Advice:

• Wear easily visible colors and, if possible, reflective clothing.
• Clothing suitable for the weather conditions.
• Always wear sports shoes or similar.
• The use of protective equipment, such as knee and elbow pads, is highly recommended.
• A properly fitted helmet must be worn, approved by ASTM or SNELL. at all times

SAFETY ACCESSORIES

1. Helmet
2. Reflective clothing
3. Elbow pads
4.  Knee pads
5. Sports tennis or similar

USE OF THE HELMET

The use of an ASTM or SNELL certified helmet is recommended, the helmet must be worn at all times when riding your scooter.

The correct helmet should: Image 1

• Be comfortable
• Have good ventilation
• Fit correctly
• Covers the forehead

Incorrect helmet position: Image 2

• The helmet does not cover the forehead image.

BATTERY

Use a battery or charger other than the vorago one. Rechargeable batteries and charger can cause fire or explosion. Use only the vorago battery and charger.

Using other rechargeable batteries and charger from any other product may result in overheating, fire, or explosion. Never use the charger or batteries with another product.

Tampering with or modifying the electrical circuit system can cause shock, fire, or explosion and permanently damage the system. Exposed wiring, circuitry in charger can cause electric shock. Always keep the charger case closed.

Contact between the positive and negative terminals can cause fire or explosion. Avoid direct contact between the terminals. Holding the battery by the cables or charger can damage the battery and may cause a fire. Always take the battery by its case.

Battery liquids can cause fire or electric shock. Keep all liquids away from the battery and keep the battery dry.

Stop using the scooter if the battery starts to smell, overheats, or starts to leak. Do not touch any leaking materials or breath vapors.

Seek immediate medical assistance if you are exposed to any substance emitted by the battery.

This battery contains dangerous substances. Never open the battery or insert something into the battery.

Lithium ion batteries are considered hazardous materials. Follow all federal, state, and local laws. Regarding the recycling, handling and disposal of lithium ion batteries

HOW TO FOLD YOUR SCOOTER

Make sure the scooter is off, hold the front post, loosen a locking lever, and lower the steering rack. Add a steering rack in a horizontal position and secure it by inserting a hook through the special ring, which is located on the rear wheel fender. To assemble the scooter, loosen the steering rack lock from a hook on a fender, then raise it to an upright position and lock the lever.

ADJUST THROTTLE AND BRAKES

1. Loosen the screws for the throttle and electronic brake. counterclockwise with a 3mm hex wrench and loosen the hood bolts counterclockwise with a cross wrench.
   

2. Twist the throttle and electronic brake and adjust to an angle that can be comfortably operated while driving.

3. Tighten the throttle, electronic brake and bell bolts clockwise.

ADJUST THROTTLE AND BRAKES

If a brake is too tight: use an M5 hex key and adjust the screws counterclockwise of the brake disc tensioner pulley, slightly shorten the length of the rear brake cable, and then tighten one tensioner pulley. If you think the brake is too free, loosen one idler pulley, pull on one brake cable to slightly increase the length of its tail. Tighten one idler.

Steering rack: Using an M5 hex key, tighten two screws near the folding mechanism.

If a rear wheel goes flat, connect a connecting tube to the wheel nipple to pump it up. First, remove the cap from the pin, then tighten it and start pumping.

STARTING THE SCOOTER

To turn on/off, press the button 1 second.
To turn on/off the front and rear light, press the button twice.
To select the speed, briefly press the button. The different gears with their corresponding speeds are listed in the following table

1. 0-6km/h
2. 7-15km/h
3. 15-25km/h

Battery: There are a total of 4 LEDs, which indicate the battery level. If all 4 LEDs are on, the battery level is 70% to 100%; if the 3rd LED lights up, the battery level is 50% to 69%; if 2nd LED lights up, battery level is 10% to 30%. If lst LED, the battery level is less than 10%, please charge the scooter.

RECHARGE SCOOTER

When the charger light is red it indicates that it is charging. When the charger light is green it indicates it has finished charging.

DATA SHEET

*Autonomy may vary due to the weight of the driver.

Limited product warranty

vorago equipment and / or accessories are covered by a limited warranty for the time indicated in the annexed validity table, counting from the date of acquisition, against any manufacturing and operation defect, provided they have been used under normal conditions of use durinp the warranty period and for which it was manufactured. Vorago warranty the buyer the absence of anomalies regarding the materials.

Important warranty policy: Please read and complete this warranty policy and seal it in the store when purchasing the product.

Product: Electric scooter|
---|---
Model: 5c-30a-vZ| Dealer stamp
Brand: Vorago
Serial number:
Invoice number:
Delivery date:

Responsibilitles

The total responsibility of vorago will be to repair or replace the product, including labor and parts, at no cost to the buyer when it is returned to the point of sale, presenting this warranty policy properly completed and stamped by the establishment where it was purchased. The product or Eopy of the receipt or receipt or invoice, in which data of the product the date of purchase is specified, to verify the times within the warranty. Vorago may use new parts, restored or used in good condition to repair or replace any product, at no additional East to the consumer. In the case of equipment and / or accessories that can not be repaired, the chang  will be generated by a similar product or with superior characteristics. This warranty covers the transportation expenses of the product derived fiom its fulfillment; which will be directly attributable to the supplier of the product. In all replacement products, the original warranty period will be renewed. Vorapo is governed by international standards for the manufacture of products.

How to obtain warranty support:
Warranty claims are processed through the point of sale, during the first 15 days after the purchase, as long as they meet the requirements. Guarantee claims that can not be processed through the point of sale and any concerns related to the product purchased should be sent with the prepaid guide by Vorago to the address of the Vorago headquarters in Francisco Villa No. 3, Col. San Agustin, CP 45645, Tlajomulco de Z6niga, Jalisco, Mexico.

Except in situations of force majeure or fortuitous event, the repair time in no case will be greater than 30 calendar days from the date of receive of the equipment in Vorago.

Exclusions
This warranty is has valid in the following cases:

• a) When the product had been used in conditions other than normal.
• b) When the product has not been operated in accordance with the instructions for use.
• c) When the product has been altered or repaired by unauthorized persons by Vorago.

Vorago does not offer any other express warranty for this product. To make the warranty valid, as well as the acquisition of parts, components, consumables and accessories.

To validate a warranty, the following information must be sent to the email: garantiasavoragolive.com

1. Model and color
2. Product failure
3. Ticket or purchase invoice (digitized)
4. Your address with CP, telephone and full Name.

Available in the establishment where the product was purchased and / or in our central offices:

Returns
In the case of product return, it will only be the place of purchase by the end customer. Subject to the return policies established by the same seller.

Vorago, S.A. de C.V.
Francisco Villa No. 3 Col. San Agustin, C.P. 45645 Tlajomulco de Zuniga, Jalisco, Mexico. Tel. (33) 3044 6666

Importadora Global Rida S.A. de C.V.
Matilde Marquez No. 68 Colonia Penon de los Banos C.P. 15520 Alcaldia Venustiano Carranza, CDMX RFC: IGR1510164C2

``

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>