COYOTE CIC28 Series CIC28LP 28-Inch Built-In Grill Installation Guide
- June 4, 2024
- COYOTE
Table of Contents
COYOTE CIC28 Series CIC28LP 28-Inch Built-In Grill Installation Guide
DIMENSIONAL RENDERINGS
Overall Product Dimensions
Model No.| Height| Width| Depth
C1C28| 23″| 28″| 25 1/2″
CJAKTCC2| 11″| 30 1/8″| 23″
Cutout Dimensions for Island
Model No.| Height| Width| Depth
C1C28| 10 1/4″| 25″| 20 1/2″
CJAKTCC2| 11″| 28 1/4″| 22 1/8″
When using a Coyote insulated jacket, you will want to build your island to the jackets Cutout and Overall Dimensions listed above. Once the jacket is installed, the grill will rest on/inside the insulated jacket
Model No.| Gas Supply| BTU’s| Regulator| WC Pressure| Max PSI| Electrical
Requirements
---|---|---|---|---|---|---
C1C28LP| Propane| 40,000| 20 lb Tank Regulator| 11″| .5 PSI| Qty 1 – 120 VAC
60 Hz Grounded Plug
C1C28NG| _ Natural Gas| 40,000| 1/2″ Female Pipe| 4″| .5 PSI| _ Qty 1 –
120 VAC 60 Hz Grounded Plug
Important Note to Installer: This file is not intended to replace your Owners’ Manual which contains specific safety requirements and consumer guidelines. Please refer to your Owners’ Manual prior to installing or operating your built-in grill.
NON-COMBUSTIBLE CONSTRUCTION
Insulated Jacket Required – Model # CJAKTCC2
- Combustible material can not be within 24″ of the grills frame
- This applies to all directions – horizontal & vertical
- Shaded area above on “TOP VIEW” illustrates the 24″ minimum requirement (not to scale for rendering purposes)
- The grill is designed to hang from the counter top with no support underneath
- Minimum rear clearance for the hood to open is 2″
- If you have a wall/partition behind the grill, the minimum rear clearance to that wall should be at least 7″ to allow for ventilation of the exhaust
COMBUSTIBLE CONSTRUCTION
Insulated Jacket NOT Required
- If using combustible material within 24″ of the grill frame, you MUST use the corresponding Coyote Insulated Jacket
- Using a insulated jacket, does not waive any other standard installation procedure (ventilation, connections, etc)
- The jacket is designed to hang from the counter top with no support underneath
- Minimum clearance for hood to open is 2″
- If you have a wall/partition behind the grill, the minimum rear clearance to that wall should be at least 7″ to allow for ventilation of the exhaust
Ventilation Requirements
- Regardless if you are using a combustible or non-combustible building material, you must include at least two vents within the island.
- These vents must be at least 20 sq. in. each and allow fresh air to move from the grill cabinet to the exterior environment.
- For a propane setup, the vents should be installed lower as propane is heavier than air.
- For a natural gas setup, the vents should be located higher in the island, as natural gas is lighter than air.
- Do not locate the two vents on the same wall of the island. Cross ventilation is key to allow any excess heat or trapped gas to dissipate.
Important Note to installer This file is not intended to replace your Owners’ Manual which contains specific safety requirements and consumer guidelines. Please refer to your Owners’ Manual prior to installing or operating your built-in grill.
Scan OR Code for brief safety and installation video.
www.coyoteoutdoor.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>