Coyote Robotic Pool Cleaner User Manual

June 12, 2024
COYOTE

Coyote logo

Coyote Robotic Pool Cleaner

Product Information

The COYOTE robotic pool cleaner is an automatic cleaning equipment designed for pools. It features a rechargeable battery and a self-beaching function when the battery is running out. The cleaner comes with a charger, a top cover, a filter tray, a chassis, a floating handle, and a brush.

Specifications

  • Charger: Charger plug, ON/OFF knob, and indicator light
  • Top cover
  • Filter tray
  • Chassis
  • Floating handle
  • Brush
  • Working voltage: 12.6V
  • Power: 50W
  • Battery life: Max. 100min
  • Rated input voltage of adapter: AC 100V-240V
  • Input power of adapter: 47Hz-63Hz
  • Rated output current of adapter: 1.8A
  • Rated output voltage of adapter: 12.6V
  • Charging time: 5-6h
  • Battery capacity: 6600mAh
  • Max. cleaning surface: 100 m²
  • Filter capacity: appr. 10 m³/h
  • Filter capability: 180µm
  • Climbing slope: 15°
  • Pool water temperature: 10°C-35°C
  • Moving speed: appr. 16 m/min
  • IP Grade: IPX8 (main body)
  • Charging environment temperature: 0-45°C
  • Max. water depth: 2.0m
  • Size: 400 x 360 x 270 mm (LxWxH)
  • Weight: 5.5 kg
  • Storage condition:
    • Short term (less than 1 month): -20°C – 60°C ≤75%
    • RH Medium term (less than 3 months): -20°C – 45°C ≤75%
    • RH Long term (more than 3 months): -20°C – 20°C ≤75%RHCoyote Robotic Pool Cleaner-fig-1

Product Usage Instructions

Important Precautions
  1. Put into or lift out from the pool with the cleaner bottom toward the wall to avoid any possible scratches to the pool.
  2. Install the brush before use to avoid possible dirt leaks.
  3. Ensure that the top cover of the cleaner is tightly assembled with its chassis.
  4. Power off the cleaner after use.
  5. Stay on the water surface for 10-15 seconds until water flows out from the cleaner to the pool before placing it on the ground.
  6. Lift the handle or clips of the cleaner out from the pool.
  • Strictly prohibit using the cleaner beyond its operating conditions. Please read the manual carefully, and use it according to the manual. We are not held liable for any loss or injury caused by improper use.
  • Use the accessories recommended or sold by the manufacturer only.
  • This model mainly applies to swimming pools with flat floor.
  • The cleaner should not be used by children under the age of 8 or people with mental disorders. Please do so under the supervision of the guardian if necessary. Please do not allow children to ride on it or play as a toy.
  • Use the original and authorized adapter only.
  • It must be replaced by the after-sale professionals if the power line is damaged.
  • Do not power on the cleaner when it is outside of the water.
  • The power line must be connected to a leakage protective and earthed socket when charging.
  • Do not operate the cleaner when there are people in the pool.
  • Always clean and wash the filter tray after use.
  • Power off the cleaner when maintaining, cleaning or not using it.
  • The cleaner should be stored in a cool and ventilated place, away from direct sunshine.
  • Charge the battery under the permitted condition. The cleaner should be stored in a cool place when charging, meanwhile do not place or be covered with anything to prevent the damage of internal electrical components caused by overheating of the power unit.
  • Only professionals can disassemble the sealed driving kit of the cleaner.
  • Close the pool filtration system before use.
  • Slightly water pollution might occur in case grease in motor oil seal leaks.
  • The cleaner is only suitable for small pools limited by battery capacity; otherwise it will affect the cleaning effect.
  • The cleaner should be charged and discharged a cycle every three months if it needs to be stored for a long time. Please use the original and authorized adapter only and ensure that the battery power is maintained at 40%-60%. The battery voltage will drop lower than the over-discharge protection voltage level due to the self-discharge of battery if not charging the battery for a long time, which will lead to fatal damage to the battery. Please be careful.
  • Prohibit charging the battery under the condition of fire or extreme heat. Do not use or store the cleaner near the heat source.
  • Prohibit piercing the cleaner shell with nails or other sharp objects, and prohibit hammering, impac-ting or throwing the cleaner

Introduction

The robotic pool cleaner COYOTE is a new type of rechargeable automatic cleaning equipment with the function of self-beaching when the battery is running out. Please read this manual carefully before use so that you can use it correctly.

Operation instructions

  1. Precautions
  2. Put into or lift out from pool with the cleaner bottom toward the wall to avoid any possible scratch to the pool.Coyote Robotic Pool Cleaner-fig-2

  3. Install the brush before use to avoid possible dirt leaks.Coyote Robotic Pool Cleaner-fig-3

  4. Please ensure that top cover of the cleaner is tightly assembled with its chassis.Coyote Robotic Pool Cleaner-fig-4

  5. Power off the cleaner after use.

  6. It is necessary to stay on the water surface for 10-15 seconds until water flows out from the cleaner to the pool before being placed on the ground.

  7. Lift the handle or clips of the cleaner out from the pool.

  8. Quick Operation
  9. Connect the cleaner and home power with the adapter and charging line to charge the battery.

  10. Clean the charging port before charging.

  11. Red charging indicator light indicates the battery is charging.

  12. Green charging indicator light indicates charging is finished.

  13. Turn the switch knob to OFF before charging.

  14. Turn the switch knob to ON after putting it into the water. The cleaner will power on, and the indicator light will be steady blue. The cleaner will start working approximately 15 seconds later while the blue light flashes.

  15. The robot will automatically reverse direction once it touches the pool wall or rise up ahead and reverse for pools with a curved floor. The blue light will flash, and then the indicator light will turn into green for a few seconds for self-adaption. After that, the indicator light will turn into blue again.

  16. After completing its working cycle, the cleaner will continue running for about 2 minutes to pull over to the pool edge. Then it will enter standby mode, and the indicator light will be steady red.

  17. To power off the cleaner, switch off the knob until the robot powers off.
    Always remember to clean the filter tray after use.Coyote Robotic Pool
Cleaner-fig-6

  18. Functions and settings of nozzles

There are two nozzles on the cleaner, one of them opens once the other closes. Water flows out through the open nozzle to thrust the cleaner to move forward. Adjust the nozzle by turning it to control the moving route.Coyote Robotic
Pool Cleaner-fig-7

1. Settings of nozzle angle and moving route
  1. The nozzles of the cleaner are marked with angles (0°- 40°).
  2. The cleaner moves in an approximately straight line when the nozzle angle is 0°.
  3. The cleaner moves in a more curved line at a larger angle from 0°- 40°.
2. Recommended three CYCLEs and nozzle settings  

Setting 1: default settings 0° — 20° / for most of poolsCoyote Robotic Pool
Cleaner-fig-8

Setting 2: 0° — 40° / when the cleaner does not have a full coverage of poolCoyote Robotic Pool Cleaner-fig-9

Setting 3: 20° — 20° / for round poolCoyote Robotic Pool Cleaner-
fig-10

Note: above are recommended settings and different settings might apply to specific pools. So the operator can set according to the principle of nozzle settings and the actual situation of the pool.

  1. Clean the filter tray
  2. Open the cleaner by clipsCoyote Robotic Pool Cleaner-fig-11

  3. Take off the filter tray

  4. Clean the filter tray and chassisCoyote Robotic Pool Cleaner-fig-13

  5. Reassemble the cleaner

  6. Push the clips on

Functions and Settings of Nozzles

The cleaner has two nozzles. One opens while the other closes. Water flows out through the open nozzle to thrust the cleaner forward. You can adjust the nozzle by turning it to control the moving route. Different settings may apply to specific pools, so operators can set it according to the principle of nozzle settings and the actual situation of the pool.

Cleaning the Filter Tray
  1. Open the cleaner by clips.
  2. Take off the filter tray.
  3. Clean the filter tray and chassis.

Troubleshooting

Coyote Robotic Pool Cleaner-fig-16

IMPORTANT
Do not return the product to the store. Contact the local after sales service on http://support.poolstar.fr

Warranty

Poolstar products have been inspected and found free of defects prior to leaving the factory. Poolstar warrants this product against defects in material and workmanship for a period of two (2) years. The warranty period begins on the date of purchase and Poolstar requires presentation of the original proof to purchase to ascertain the date. During the warranty period, Poolstar will either repair or replace, at its discretion, any defective products. Replacement products or repaired parts will be warranted for only the unexpired portion of the original warranty.

Shipping cost policy
The return of defect parts to the authorized service center is at the charge of the owner. On warranty period, the return is at the charge of service center.

Warranty policy
This limited warranty does not apply to any defect resulting from negligence, accident, misuse, or other reason beyond Poolstar’s reasonable control, included but not limited to: normal wear and tear, negligence or failure to follow the product instructions, improper or inadequate maintenance; connection to improper power supply; chemical water damage, loss of pool water, unauthorized product modification or repair; use for commercial purpose; fire, lightening, flood or other external causes. This warranty is valid only in the country of purchase in such countries where Poolstar sells and services the same model with identical technical specifications. Warranty service outside the country of purchase is limited to the terms and conditions of the correspon-ding warranty in the country of service. Where the cost of repairs or replacement is not covered by this warranty, Poolstar will advise the owners and the cost shall be charged to the owner. This warranty only applies to the original purchaser and terminates upon any transfer of ownership. All repairs of which warranty claims are made must be pre- authorized by a Poolstar service center. All the authorized selling dealer is responsible for all in-field service work carried out on your Poolstar product. Poolstar will not be liable for results of cost of workmanship from unauthorized service person.

ROBOTIC POOL CLEANER LIMPIAFONDOS AUTOMATICO

Coyote is a trademark of Poolstar group

https://wszystkodobasenow.pl/odkurzacz-basenowy-coyote

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

COYOTE User Manuals

Related Manuals