Akuvox IT88X Indoor Monitor Installation Guide

Akuvox IT88X Indoor Monitor

Unpacking

Before you start using the device, please check the product version, and ensure that the following items are included in the shipped box:

Product Overview

Installation

Step 1: Flush-mounting Box Installation

• Mark where the box will be located,, and cut out a rectangular hole (heightwidthdepth=l66241 40mm) in the wall. Fit the flush-mounting box into the hole, and run cables through it.
  Note: The maximum height from the gound to the hole’s bottom edge is 1012 mm.

• Fill the gap between the wall and flush-mounting box with cement or non-corrosive structural adhesive. The adhesive must dry before you continue to the next step.

Step 2: Flush-mounting Bracket Installation

• Make sure the cables go through the hole of the flush-mounting bracket. Fasten the bracket to the box using four M4x20 crosshead screws.
• The flush-mounting bracket installation is done.

Step 3: Device Installation

• Connect cables to the corresponding ports on the back of IT88X (please refer to the Device Wiring section).

• Rotate the device at 15° as the figure shown. Align the two upper holes on the back cover with the hooks of bracket. Press the device into the bracket until it is clipped on.
  Note: Make sure the screw holes at the bottom of the device align tothe bracket’s.

• Use Allen wrench to tighten the M3x6 headless screw at the bottom of the device. Device installation is done.

Device Wiring

Warning

When you connect a device containing a oil, yor n ctromagnetic clock, itis sucha sare lanecessary to protect ele the intercom against the voltage peaks while switching off th e induction load. Forth is way of protection we recommend a diod.

Device Removal

• Before removing the device from the bracket, remove M3x6 headless screw at the bottom.

Application Network Topology

Configuration

1. Access basic information: After setting up network and power, go to Setting> System Info to check Account and Network status, and Version info.
2. Access the Website: Type the IP address of the device into the broswer, then enter the username and password to login (user name/password: ad min /ad min by default).
3. Account Registration: On web interface, go to Account> Basic to fill in the account information, and click Submit to confirm (Please refer to user manual for more information).

Operation

Make a call:
Enter the called’ s number or room address, then press Dial icon to make an audio call, or press Video icon to make a video call. Press icon to hang up.

Receive a call:
Press  icon to pick up an incoming video call or press icon to pick up an audio call.

Unlock:
During a call, you can press Unlock icon on the talking interface to unlock the door.

Monitor:
Press Monitor icon to see the video stream from the door phone or from third- party devices.

Notice Information

Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com © Copyright 2022 Akuvox Ltd. All rights reserved. AKUVOX (XIAMEN) NETWORKS CO., LTD.

Add.: 10/F, NO.56 GUAN RI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA www.akuvox.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>