Akuvox X912 IP Vandal Resistant Smart Door Intercom Unit User Guide

May 15, 2024
Akuvox

Akuvox X912 IP Vandal Resistant Smart Door Intercom Unit

Akuvox X912 IP Vandal Resistant Smart Door Intercom
Unit

Unpacking

Before you begin using the device, please check the version you got and ensure that the following items are included in the shipped box:

  • Rotary bracket x1
    Unpacking

  • M4X10 crosshead screw x5

Installation

As figure shown, mark four screw holes on the position that according to the cable place. The horizontal distance of two holes should be 50 mm, and the vertical distance of two holes should be 180 mm. Then use a hand drill with a diameter of 6 mm to drill the four marked holes with a depth of 20 mm.
Installation

Insert the four plastic wall anchors into the drilled holes.
Installation

Rotate right in 30 degrees
Installation
Or
Rotate left in 30 degrees

Rotate right 30 degrees
Installation
Or
Rotate left in 30 degrees
Installation

Pace the rotary bracket closely against the wall while lining up its four holes with their corresponding drilled holes. And then fasten the rotary bracket on the wall by tightening four ST4x20 crosshead screws to the plastic wall anchors.

Fix wall-mounting bracket with five M4x10 crosshead screws on the rotary bracket.

Note Information

Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com © Copyright 2022 Akuvox Ltd. All Rights reserved.
QR Code

Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals