CONAIR BE200W LED Lighted Mirror Instruction Manual

June 9, 2024
ConAir

CONAIR BE200W LED Lighted Mirror

CONAIR-BE200W-LED-Lighted-Mirror-product

IMPORTANT SAFETY INSTRUCTIONS

WHEN USING AN ELECTRICAL FURNISHING, BASIC PRECAUTIONS SHOULD ALWAYS BE TAKEN, INCLUDING THE FOLLOWING:

READ ALL INSTRUCTIONS BEFORE USING THIS FURNISHING

DANGER
TO REDUCE THE RISK OF ELECTRIC SHOCK, ALWAYS UNPLUG THIS FURNISHING FROM THE ELECTRICAL OUTLET BEFORE CLEANING OR SERVICES AFTER CLEANING.

WARNING
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:

  1. Unplug from the outlet before putting on or taking off parts.

  2. Close supervision is necessary when this furnishing is used by or near children or individuals with certain disabilities.

  3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.

  4. Never operate this furnishing if it has a damaged cord or plugs if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
    Return the mirror to a Service Center for examination and repair.

  5. Keep the cord away from heated surfaces.

  6. Never drop or insert any object into any opening.

  7. Do not use outdoors.

  8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

  9. To disconnect, turn all controls to the OFF position, then remove the plug from the outlet.

  10. Do not leave the appliance unattended when it is plugged in.

  11. Be sure the mirror is not in a position where it can reflect sunlight; reflected sunlight can cause a fire.

  12. Do not use it on a soft surface, such as a bed, where openings may be blocked.

  13. Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair, and the like.

  14. Turn the switch to the OFF position, allow the unit to cool, and unplug the cord before replacing the lightbulbs.

  15. Do not place or store this furnishing where it can fall or be pulled into a tub or sink.

  16. If this furnishing falls into water, unplug it immediately. Do not reach into the water.

  17. To protect against electrical hazards, do not use it while bathing or in the shower.

  18. Never use it while sleeping.

  19. Do not use a bulb greater than 6.5 watts.

  20. Use on any 120 volts 60 hertz AC electric outlet (ordinary house current). Do not use it on any other electrical outlet.

  21. This appliance is not a toy. Keep away from children.

FOR HOUSEHOLD USE ONLY

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

To reduce the risk of electric shock, this mirror has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Never use with an extension cord unless plug can be fully inserted. Do not change the plug in any way.

  1. Your lighted makeup mirror will adjust to different angles. Simply tilt the mirror housing back and place the metal brace in the desired slot on the bar.
  2. Insert plug into any standard wall outlet (120 volt AC).
  3. To turn on the light, simply press the power button on the side of mirror and then push mode switch button on the front of the mirror for the desired light setting.
  4. After use, switch the power button to off, unplug and store the mirror in a safe location.

SPECIAL FEATURES

This lighted makeup mirror uses lifetime, energy-saving LED bulbs that do not need to be replaced.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH THE WIDE BLADE OF THE PLUG TO THE WIDE SLOT, AND FULLY INSERT.
CAUTION: RISK OF FIRE, USE ONLY 6.5 WATTS MAXIMUM 120 VOLT, TYPE T BULBS.

DISCONNECT FROM THE SUPPLY CIRCUIT BEFORE SERVICING OR CLEANING.

DO NOT SUBMERSE.

  • MODEL: BE200
  • RATING: 120V AC 60Hz 0.12A 6.5W

GET TO KNOW YOUR LIGHTED MAKEUP MIRROR

FEDERAL COMMUNICATIONS COMMISSION NOTICE

WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

SUPPLIER’S DECLARATION OF CONFORMITY

  • Brand: CONAIR®
  • Model No.: BE200
  • Description: Lighted Mirror
  • Responsible Party: Conair Corporation, 1 Cummings Point Road, Stamford, CT 06902 203-351-9000
  • Standards: FCC Part 15 Subpart B, ANSI C63.4-2014

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

DATE OF ISSUE: 11/10/2020

MAINTENANCE

Your lighted mirror is designed for household use and is virtually maintenance-free. No lubrication is needed. If cleaning becomes necessary, disconnect the appliance from the power source and wipe the exterior with a damp cloth. Clean mirror surfaces with a glass cleaner. If any abnormal condition occurs, unplug the lighted mirror, allow it to cool, and return it to an authorized service representative for repair.

SAFETY WARNINGS

If the mirror is not in use, disconnect it from the electrical outlet. BE SURE DIRECT SUNLIGHT WILL NOT STRIKE the MIRROR WHEN LEFT UNATTENDED; reflected sunlight may cause a fire. Allow it to cool to room temperature before storing. Place it in a cool, dry area, out of reach of children, and where it will not be damaged. Handle the cord carefully for longer life. Do not jerk or strain at plug connections or wrap the cord around the mirror for storage. This could cause the cord to become damaged and short-circuit. To store the mirror, coil the cord loosely and place it in large loops next to the mirror or secure the cord with a twist tie.

WARNING:
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG.

KEEP AWAY FROM WATER

Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.

ALWAYS UNPLUG SMALL APPLIANCES

LIMITED ONE-YEAR WARRANTY

(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.

IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

Please register this product at www.conair.com/registration.

For info on any Conair product, call 1-800-3-CONAIR or visit us on the web at www.conair.com.

Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307

©2021 Conair Corporation 20PM075326.

For your safety and continued enjoyment of this product, always read the instruction book carefully before using it. MODEL BE200.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals