VENTURE LIGHTING AS0042 LED Troffer Fixture with Battery Backup User Manual

VENTURE LIGHTING AS0042 LED Troffer Fixture with Battery Backup

Before You Begin

Read These Instructions Completely and Carefully

Upgrade Instructions

• STEP 1: Disconnect power from the existing luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.

• STEP 2: Remove the existing luminaire. Dispose of the lamp(s) and ballast(s)  per local requirements.

• STEP 3: Each corner of the fixture has a mounting tab (4 mounting tabs total). Bend each mounting tab up and then bend the tab again (approximately 90°) so the mounting tab can be secured to the T-grid. (A)
  

• STEP 4: Place the fixture into a T-grid. (B)
  

• STEP 5: Ensure the mounting tab is securely hooked onto a T-grid.

• STEP 6: Remove the wiring compartment cover plate. (C)
  

• STEP 7: Make the necessary wiring connections as shown in the wiring diagram. (D)
  
  NOTE: The wiring between the battery backup, fixture test switch, driver(s) and LED modules is already completed. There are two black input wires: the flagged black wire should be connected to continuous (or unswitched) input power.
  When power is interrupted on this wire, the fixture will enter battery backup mode. The unlabeled input wire should be connected to the switch or control that will turn the fixture on and off under normal circumstances.
  NOTE: The polarity of the dimming connections is important to ensure the performance as desired.
  NOTE: If not using the dimming functionality, DO NOT connect the Driver Dim+ (purple) to the Driver DIM- (pink). The fixture will not operate as desired.

• STEP 8: Replace and secure the wiring cover plate.

• STEP 9: Power can now be restored to the fixture.

WARNING

Risk of fire and electric shock

• Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
• Venture Lighting’s LED Troffer Fixture installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• The product should be installed and operated by a qualified electrician or technician in accordance with relevant local codes.
• Check to make sure that all fixture connections have been properly made and the fixture is grounded to avoid potential electrical shocks.
• Do not handle energized fixture when hands are wet, when standing on wet or damp surfaces, or in water.
• Suitable for use in damp and dry locations.
• Venture Lighting’s LED Troffer Fixture is Type IC.
• Use minimum 90°C supply conductors.
• The installer must determine that the supply voltage meets the fixture requirement.

CUSTOMER SERVICE

800-451-2606
6675 Parkland Blvd., Suite 100
Solon, Ohio 44139 USA
E-mail: Venture_Lighting@VentureLighting.com
VentureLighting.com

© 2022 Venture Lighting International Venture Lighting is a registered trademark of Venture Lighting International.

References

• LED Lighting Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>