VENTURE LIGHTING AC0001 High Bay Series Pendant or Hook Mount Installation Guide

October 30, 2023
VENTURE LIGHTING

VENTURE LIGHTING AC0001 High Bay Series Pendant or Hook Mount Installation Guide
Light Hook Mount

Dimensions shown in inches

Product Dimension

WARNING : Before proceeding, read all instructions carefully to ensure proper and safe installation.
WARNING: Risk of fire or electrical shock.
WARNING: Disconnect power before installing or servicing.
WARNING: All wiring to be performed per National Electrical Code and local code by a qualified electrician.
WARNING: Check to make sure that all the input power connections have been properly made and the module is grounded to avoid potential electrical shock.
WARNING: Please follow all UL, NEC and minimum load rating guidelines when selecting and installing a cable or chain.
WARNING: Contractor responsible for any and all safety cable installation.

Hook Mount/Pendant Mount Adapter Installation Only
Remove 4 screws that hold the Hook/Pendant Mount to fixture. If Hook Mount is originally installed, remove the wire that is fed through the strain relief. If Pendant Mount is originally installed, then you will need to feed the wire through the strain relief on the hook mount. Install the alternative mount to the fixture with the 4 screws originally removed

For Hook Mount Adapter:
For balancing the fixture when mounted, loosen the adjustment screw on top of mount and slide hook as necessary. Tighten adjustment screw when finished.

Pendant Mount Installation
Feed the electrical wire leads coming out of the fixture through the customer supplied 3/4” threaded conduit pipe. Makeelectrical connections per the Wire Diagram then secure to appropriate external mount.

Hook and Cord Mount Installation:
Remove latch screw on hook mounting system and swing open to slide hook into the customer supplied eye hanger. Then install latch screw back on Hook Mount system.

Screw view
Installation

Reflector Installation
To install, reflector loosen the 3 tabs on the trim plate of fixture and shift the tabs so that reflector can be placed around trim plate. Once in place, swivel tabs over reflector to secure into place. Then hand tigthen so tabs and reflector are secure.

Tab location

Safety Cable Installation

Make sure safety cable bracket is secured to the back side of the fixture. Pass one of the safety cable loops through the attached bracket, then run the opposite loop of the safety cable loop through the loop of the end which was run through the safety cable bracket. Take the other end of the hanging cable and affix to appropriate external mount point.

Cable Bracket

Electrical Diagram

You can refer to the electrical diagram below for further information.

Wiring Diagram

Sensor Arm Installation

Reference the electrical diagram to insure proper installation of sensor per manufacturers instructions. Make sure appropriate lengths of wire are fed through the sensor arm pipe prior to installation of Sensor Arm. First, remove knockout located on the fixture and feed sensor wire and secure connections. Proceed to mount the arm as shown in the diagram below.

Installation Instruction

Below references the sensor enclosure where you will secure the sensor through the knockout. Close the sensor enclosure by reinstalling the four screws to the sensor arm.

Installation Instruction

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

VENTURE LIGHTING User Manuals

Related Manuals