VENTURE LIGHTING AE0001-D LED Retrofit Lamp User Manual

June 2, 2024
VENTURE LIGHTING

VENTURE LIGHTING AE0001-D LED Retrofit Lamp

VENTURE-LIGHTING-AE0001-D-LED-Retrofit-Lamp-PRODUCT

Before You Begin

Read These Instructions Completely and Carefully

WARNING
Risk of electric shock

  • Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
  • Venture Lighting LED Retrofit lamp installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
  • Venture Lighting LED Retrofit lamps require 100V-277V input voltage. The installer is responsible to determine whether the proper voltage is run to the luminaire being serviced.
  • Venture Lighting LED Retrofit lamps operate on line voltage and require all ballasts, capacitors and starters to be bypassed and/or removed.
  • Suitable for use in dry or damp locations only. Do not use where directly exposed to liquid, vapor, rain or weather.
  • This device is not intended for use with emergency exits.
  • This device is not intended for use with dimmers or remote controls.
  • The device is suitable for enclosed fixtures, however ensure that there is adequate space around the device for heat dissipation.
  • The device uses a passive heat sink for heat dissipation. Do not block or cover the lamp as it will adversely affect the lamp performance and lamp life.
  • The modified fixture can no longer operate as was originally intended.

Upgrade Instructions

  • STEP 1 : Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
  • STEP 2 : Remove the existing lamp. Dispose of the lamps per local requirements.
  • STEP 3 : Disconnect and remove the existing ballast, capacitor and ignitor. Dispose of the components per local requirements. STEP 4: Connect the Line Live wire (Line/Hot) to the center contact (eyelet) of the lamp holder.
  • STEP 5 : Connect Line Neutral wire (Common) to the shell of the lamp holder.
  • STEP 6 : Insert and screw in the LED Retrofit lamp into the lamp holder.
  • STEP 7 : Close the wiring compartment. Watch to be sure the wires are not pinched, bound or crimped when closing the compartment.
  • STEP 8 : Attach the Lamping Replacement Label which is provided with the retrofit lamp to the fixture so it shall be visible during relamping.
  • STEP 9 : Switch on the power.

Minimum Required Lamp Compartment Dimensions

  • For LED Retrofit lamps 8W through 22W
  • Note : It is the customer’s responsibility to verify that the lamp compartment meets the minimum required lamp compartment dimension of 6″ diameter by 8.5″ long.
  • For LED Retrofit lamps 27W through 54W
  • Note : It is the customer’s responsibility to verify that the lamp compartment meets the minimum required lamp compartment dimension of 8″ diameter by 11″ long.

Wiring Diagrams

Replacing Self Ballasted CFL Lamp

VENTURE-LIGHTING-AE0001-D-LED-Retrofit-Lamp- \(1\)

Replacing HPS/HID Lamp

VENTURE-LIGHTING-AE0001-D-LED-Retrofit-Lamp- \(2\)

800-451-2606
6675 Parkland Blvd., Suite 100
Solon, Ohio 44139 USA
E-mail: Venture_Lighting@VentureLighting.com
VentureLighting.com
© 2022 Venture Lighting International • Venture Lighting is a registered trademarks of Venture Lighting International.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

VENTURE LIGHTING User Manuals

Related Manuals