NIKKO 10310NIKCOL Nano Rock Crushr RC User Manual

NIKKO 10310NIKCOL Nano Rock Crushr RC User Manual

PRECAUTION

WARNING! CHOKING HAZARD
Not suitable for children under 36 months due to small parts.

Only operate the product and its accessories when fully assembled and in accordance with this manual!

• Do not use this vehicle in water, mud, or sand.
• This product and its accessories are not suitable for children under the age of 36 months, because of small parts that can be swallowed.
• Intended for children age 6 and older.
• Adult supervision strongly recommended.
• Drive your vehicle in a safe area away from people, pets, cars, etc.
• Do not drive on streets or after dark.
• Do not touch or try to pick up the vehicle when it is in motion. Wait until it has stopped completely.
• Keep hair, fingers, face and loose clothing away from front and rear wheels while the vehicle is switched on or while the controller is operating.
• Be a responsible operator.
• Do not drop or give impact to the product and its accessories.
• Never attempt to disassemble or modify the product or its accessories.

IMPORTANT BATTERY SAFETY INFORMATION.

CAUTION: TO AVOID BATTERY LEAKAGE.
NOTE: BATTERIES MUST BE RECYCLED OR DISPOSED PROPERLY.

Contact your local area office of solid waste management or other appropriate local agency for information.

• Make sure the batteries are inserted with correct polarity and follow the toy and battery manufacturer’s instructions.
• Use only battery type(s) recommended.
• Do not attempt to short-circuit, charge, disassemble or heat batteries.
• Do not dispose of batteries in fire or make them wet.
• Do not mix or use new and old batteries together.
• Do not mix or use different types of batteries together.
• Non-rechargeable batteries are not to be recharged because of the danger of eruption.
• Remove rechargeable batteries from the product before charging.
• Rechargeable batteries are to be charged by adult only.
• Battery replacement should be done in presence of an adult and follow the battery and charger manufacturer’s instructions.
• Remove batteries from the product for storage. Battery may be hot.
• After use, be sure to turn the switch off. Failure to do so may adversely affect batteries, resulting in disabled charged.
• Remove weak or exhausted batteries from the product.
• Dispose batteries safely and properly, according to your local requirements.
• Chargers used with the toy are to be regularly examined for damage to the cord, plug, enclosure and other parts, and that, in the event of such damage, the toy must not be used with this charger until the damage has been repaired.

I – BATTERY INSTALLATION AND CONTROL LINKING

IMPORTANT:

• This vehicle uses an automatic system to link the vehicle with the controller. For multi vehicle play, this process must be completed one by one for each vehicle.
• Attempting to link multiple vehicles at the same time will cause miss matching of controllers.
• If the controller and the vehicle cannot link, please repeat the steps 1-4 to re-link.

NOTE: There is no ON/OFF switch on the controller. Moving the sticks turns it on automatically. For best performance, always use alkaline batteries only. To remove the batteries, reverse the installation procedure.

TROUBLE SHOOTING AND CARE FOR R/C VEHICLE

R/C VEHICLE DOES NOT MOVE| PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUN
---|---

• Is the power switch turned to ON position?
• Are the batteries weak or out of power?
• Are the battery installation and control linking completed?
• Are the + and – contacts correctly matched to the batteries?
• Are the metal contact tabs touching, rusty or dirty?

|

• Are the batteries weak or out of power?
• Check batteries. If necessary, recharge battery pack and/or replace the batteries in the R/C vehicle and controller with new alkaline batteries.
• Are the batteries installed properly?

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE

NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the userʼs authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

MANUFACTURER’S NOTE

• Modifications not authorized by the manufacturer may void users authority to operate the device.
• This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous parts be repaired or replaced.
• In the interest of better quality and value, we are constantly improving and updating our products.
• Consequently, pictures in this instruction sheet may sometimes differ from the model enclosed.
• You are advised to retain the packaging for future reference as it contains important information.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadaʼs licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Help the environment by disposing of batteries responsibly. The wheelie bin symbol indicates that batteries must not be disposed of in domestic waste as they contain substances which can be damaging to environment and health.Please remove exhausted batteries from products and use designated collection point or recycling facilities when disposing of batteries.

Symbols:

Support

SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, “Nikko Toys Ltd declares that the radio equipment type [NANO ROCK CRUSHR RC™] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.nikkotoys.com”
Keep the instruction sheet since it contains important information.
www.nikkotoys.com/FAQ

References

• NikkoToys Ltd. – Creating fun for kids
• FAQ – NikkoToys Ltd.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>