HOFTRONIC 4405212 Venezia Led Dimmable Downlight User Manual
- June 9, 2024
- HOFTRONIC
Table of Contents
4405212 Venezia Led Dimmable Downlight
User Manual
USER MANUAL
VENEZIA LED DIMMABLE DOWNLIGHT
4405212 Venezia Led Dimmable Downlight
SKU 4405212, 5436031
Imported by HOF Trading B.V.
Fahrenheitstraat 11, 6003 DC Weert
The Netherlands Made in P.R.C.
www.hoftronic.com
SAFETY INSTRUCTIONS
- Before installation or maintenance ensure that the main supply to the downlight is switched off and the circuit supply fuses are removed or the circuit breaker turned off.
- A qualified electrician MUST be used for the installation of this downlight
- This downlight must be installed to the current edition of the IEE wiring regulations and relevant building regulations in your country.
- Check that the total load of the circuit, including when this down light is fitted, does not exceed the rating of the circuit table, fuse of circuit breaker.
- This downlight is designed for indoor and outdoor use and is fire rated.
- Do not cover the downlight with insulation materials.
- Make sure that 50mm above and around the downlight is free airflow.
- The downlight should not be installed within 50mm of any joints.
INSTALLATION INSTRUCTIONS
- Test the downlight before installing for an correct operation.
- Cut a suitable hole in the ceiling as per the cut-out details ensuring that it does not interfere with electrical cable, water/gas pipes or ceiling joints.
- Carefully fold back any insulation material so as to allow at least 50mm free circulation of air.
- Remove the terminal cover on the driver by removing the screws, inserting a screwdriver into the front gap and prizing back the cover.
- Connect the main cable into the terminal block ensuring correct polarity is observed and that if stranded cable is used that all strands are terminated.
- Re-fit the terminal cover securing the mains cable under the cable clamp.
- Place the loop in loop out driver through the hole and into the ceiling cavity.
- Fit the downlight into the hole in the ceiling with the 2 spring clamb bent back.
DIMMING
The downlight comes as standard with dimmable loop in loop out LED driver that
allows the user to regulate the light output to best suit their lighting needs
PLEASE NOTE:
- The driver can be used with the most trailing and leading edge dimmers, though this is not guaranteed.
- Please examinate carefully the manufacturer’s guide on the dimmer switch you intend to use and check the compatibility.
- In some cases you may need to change your dimmer if the unit flickers or does not dim smoothly.
BEZEL REPLACEMENT
Alternative color bezels are available. The downlight has magenetic surface,
to change the bezel click very easy another bezel on the downlight.
PLEASE NOTE: THESE SPOTLIGHTS ARE NOT SUITABLE AS FLOOR OR DECK
SPOTLIGHTS
INTENDED USE / APPLICATION
Product designed for the use in households and for other similar general
applications.
MOUNTING
Technical changes reserved. Read the manual before mounting. Mounting should
be performed by an appropriately qualified person. Any activities to be done
with disconnected power supply. Exercise particular caution. Product has a
protective contact/terminal. Failure to connect the protective lead may lead
to electric shock. Mounting diagram: see pictures. Check for proper mechanical
fastening and connection to electrical power prior to first use. The product
can be connected to a supply network which meets energy quality standards as
prescribed by law. To maintain the proper IP protection level, the right
diameter of the power cable should be selected for the cable gland used in the
product.
FUNCTIONAL CHARACTERISTICS
Product can be used indoors and outdoors.
USAGE GUIDELINES / MAINTENANCE
Any maintenance work must be performed when the power supply is cut off and
the product has cooled down. Clean only with soft and dry cloths. Do not use
chemical detergents. Do not cover the product. Ensure free air access. Product
may heat up to a higher temperature. Product can only be supplied by rated
voltage or voltage within the range provided. It’s forbidden to use the
product with damaged protective cover. Product must not be used in
unfavourable conditions, e.g. dust, water, moisture, vibrations, explosive air
atmosphere, fumes, or chemical fumes, etc. Non-demountable product. Not
suitable for independent repairs.
ENVIRONMENTAL PROTECTION
Keep your environment clean. Segregation of post-packaging waste is
recommended. This labelling indicates the requirement to selectively collect
waste electronic and electrical equipment. Products labelled in this way must
not be disposed of in the same way as other waste under the threat of a fine.
These products may be harmful to the natural environment and health, and
require a special form of recycling/neutralising. Products labelled in this
way should be returned to a collection facility for waste electrical and
electronic goods. Information on collection centres is provided by local
authorities or sellers of such goods. Used items can also be returned to the
seller when new product is purchased, in quantity no larger than the purchased
item of the same type.
The above rules regard the EU area. In the case of other countries,
regulations in force in a given country must be applied. Contacting the
distributor of our products in a given area is recommended.
COMMENTS / GUIDELINES
Failure to follow these instructions may result in e.g. fire, burns,
electrical shock, physical injury and other material and non-material damage.
For more information about Hoftronic products visit
www.hoftronic.com. Hoftronic shall not be
responsible for any damage resulting from the failure to follow these
instructions. Hoftronic reserves the right to make changes in the manual – the
current version can be downloaded at
www.hoftronic.com.
DECLARATION OF CONFORMITY
DOCUMENTATION
This product has been manufactured and supplied in compliance with all
relevant regulations and directives applicable to all member states of the
European Union. The product complies with all applicable regulations and rules
in the country of sale.
Formal documentation such as the declaration of conformity, the safety data
sheet and the product test report is available upon request.
CE DECLARATION
The product complies with the following directives:
LVD: 2014/35/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
The complete Declaration of Conformity Document (DOC) is available upon
request.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>