Inels WMR3-21 Wall Card Reader Installation Guide

June 9, 2024
inELS

Inels WMR3-21 Wall Card Reader

Technical parameters

WMR3-21

Inputs

Number of control buttons:| 2
RFID readers|
Supported frequencies:| 13.56 MHz
Card Type:| MIFARE Ultralight, DESFire 2K (EV1), DESFire 4K (EV1)
Outputs
Output:| 1x changeover 8 A/AgSnO2
Indication:| two-color LED (red, green)
Acustic output:| o-color LED (red, green) piezo-changer
Switching voltage:| 230 V A/30 V DC
Switching output:| 2000 VA/AC1; 240 W/DC
Peak current:| 20 A/<3s
Insulation voltage between relay outputs and internal circuits:| 3.75 kV, SELV according to EN 60950
Minimal switched current:| 10 mA/10 V
Switching frequency without load:| 300 min-1
Mechanical life:
Installation BUS| BUS
Power supply
Supply voltage/tolerance:| 27 V DC, -20/+10 %
Dissipated power:| max. 0.5 W
Rated current:| 50 mA (at 27 V DC), from BUS
Connection
Data:| terminals, 0.5 – 1 mm2
Network:| max. 2.5 mm2 /1.5 mm2 with sleeve
Operating conditions
Operating temperature:| -20 to +55 °C
Storing temperature:| -30 to +70 °C
Protection degree:| IP20
Overvoltage category:| II
Pollution degree:| 2
Operation position:| any
Installation:| into installation box
Dimensions and weight
Dimensions|
– plastic:| 85.6 x 85.6 x 42 mm
– metal, glass, wood, granite:| 94 x 94 x 36 mm
Weight:| 68 g (without frame)

  • WMR3-21 is a wall-mounted card reader that is designed for read contactless media (smart cards, key chains, etc.), which are used for controlling access to buildings or their parts.
  • With the glass controller WMR3-21 users will appreciate the easy of control using two push buttons, which can be assigned diff erent control functions lighting, shading, scenes, heating, etc.
  • WMR3-21 reader can be used to control the security system (locking/ unlocking) access system (opening doors, gates, etc.) or appliances (based on assigned rights).
  • WMR3-21 supports RFID media with the carrier frequency of 13.56 MHz. Supported card types MIFARE Ultralight, DESFire 2K (EV1), DESFire 4K (EV1) .
  • WMR3-21 is also equipped with 8 A relay output with changeover contact AgSnO2 , by which controlled devices can be switched directly (or any actuator in the system can be set in software iDM3).
  • Indication two-color LED in the controller cover can indicate not only the status of controlled appliance, but also the status of any sensor or actuator in the system.
  • Wall card reader WMR3-21 is compatible with both types of frames LOGUS90 (85.6 x 85.6 or 94 x 94 mm), therefore you can combine them with double and triple frames and classic products of the series.

Connection

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals