KICHLER 49865WZC Andover 1-Light 14-Inch Weathered Zinc Outdoor Wall Light Installation Guide

: June 9, 2024
: KICHLER

Table of Contents

KICHLER 49865WZC Andover 1-Light 14-Inch Weathered Zinc Outdoor Wall
Help
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KICHLER 49865WZC Andover 1-Light 14-Inch Weathered Zinc Outdoor Wall

Light

KICHLER-49865WZC-Andover-1-Light-14-Inch-Weathered-Zinc-Outdoor-Wall-Light-
PRODUCT

CAUTION – RISK OF SHOCK
Disconnect Power at the main circuit breaker panel or main fusebox before starting and during the installation.

Find the appropriate threaded holes on mounting strap[1] that align with hole distance in canopy[2]. Thread mounting screws[3] into threaded holes starting from outlet box[4] side.
Attach mounting strap to outlet box with strap mounting screws[5]. Mounting strap can be adjusted to suit position of fixture.
Grounding instructions: (See Illus. A or B)
- On fixtures where mounting strap is provided with a hole and two raise dimples. Wrap ground wire from outlet box around green ground screw, and thread into hole.
- On fixtures where a cupped washer is provided. Put ground wire from outlet box under cupped washer and green ground screw and thread screw into hole in mount-ing strap. If fixture is provided with ground wire. Connect fixture ground wire to outlet box ground wire with wire connector, after follow-ing the above steps. Never connect ground wire to black or white power supply wires.
Make wire connections. Reference chart below for correct connections and wire accordingly
Connect Black or Red Supply Wire to:| Connect

White Supply Wire to:

---|---
Black| White
Parallel cord (round & smooth)| Parallel cord (square & ridged)
Clear, Brown, Gold or Black without tracer| Clear, Brown, Gold or Black with tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
*Note: When parallel wires (SPT I & SPT II) are used. The neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (see illus.)|

  * Neutral Wire

Push fixture to wall carefully passing mounting screws with holes in the canopy. Make sure all wires are inside canopy and do not get pinched between wall and canopy of fixture.

Thread lockup knobs[6] onto mounting screws and tighten to secure the fixture to wall.
Install glass[7] by sliding up over the installed bulb until seated, while supporting the glass, obtain the spacer[8] and slide up into the glass and slide over the socket. Next obtain the socket ring[9] and screw into place over the socket up to the spacer.(DO NOT over-tighten.)
Insert recommended bulb (not supplied).
INSTRUCTIONS FOR MOUNTING FIXTURES OUTDOORS AND/OR IN WET LOCATIONS.
The mounting surface should be clean, dry, flat, and 1/4” larger that the canopy on all sides. Any gaps between the mounting surface and canopy exceeding 3/16” should be corrected as required.
With silicone caulking compound, caulk completely around where back of canopy meets the wall surface to prevent water from seeping into outlet box.