KICHLER 49984DBK Springfield 1-Light 13.5-Inch Distressed Black Outdoor Wall Light Installation Guide

KICHLER 49984DBK Springfield 1-Light 13.5-Inch Distressed Black Outdoor

Wall Light

Fixture Diagram

Parts List

• [A] Mounting Strap
• [B] Outlet Box
• [C] Mounting Strap Screws
• [D] Mounting Screws
• [E] Canopy

Cautions

CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fusebox before starting and during the installation.
WARNING:
This fixture is intended for installation in accordance with the National Electrical Code (NEC) and all local code specifications. If you are not familiar with code requirements, installation by a certified electrician is recommended.

Installation Instructions

1. Attach the mounting strap[A] to the outlet box[B] using the mounting strap screws[C].
2. Grounding instructions: (See Illus. a or b).
   • On fixtures where mounting strap is provided with a hole and two raised dimples, wrap ground wire from the outlet box around green ground screw, and thread into hole.
   • On fixtures where a cupped washer is provided, attach the ground wire from the outlet box under the cupped washer and green ground screw, then thread into the mounting strap. If fixture is provided with ground wire. Connect fixture ground wire to outlet box ground wire with wire connector (Not provided) after following the above steps. Never connect ground wire to black or white power supply wires.
3. Make wire connections. Reference the chart below for correct connections and wire accordingly.
   Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
   ---|---
   Black| White
   Parallel cord (round & smooth)| Parallel cord (square & ridged)
   Clear, Brown, Gold or Black without Tracer| Clear, Brown, Gold or Black with Tracer
   Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
   *Note: When parallel wire (SPT 1 & SPT 2) are used. The neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (See illus.)|

Neutral Wire

4. Push fixture to wall. Be sure not to pinch wires between wall and the canopy of fixture. Thread mounting screws[D] into threaded holes on the long sides of the canopy[E].

5. Insert recommended bulb(s) (Not supplied).
   INSTRUCTIONS FOR MOUNTING FIXTURES OUTDOORS AND/ OR IN WET LOCATIONS.

6. The mounting surface should be clean, dry, flat and 1/4” larger than the canopy on all sides. Any gaps between the mounting surface and canopy exceeding 3/16” should be corrected as required.

7. With silicone caulking compound, caulk completely around where back of canopy meets the wall surface to prevent water from seeping into outlet box.

We’re here to help866-558-5706
Hrs: M-F 9 am to 5 pm EST

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>