KICHLER 49933WZC Bay Village 4 Light 10 inch Weathered Instruction Manual

KICHLER 49933WZC Bay Village 4 Light 10 inch Weathered Instruction Manual

CAUTION – RISK OF SHOCK –

Disconnect Power at the main circuit breaker panel or main fuse box before starting and during the installation.

1. Take threaded tube[14] and thread on two hexnuts[15] and thread into main assembly[1] as shown.

2. Place decorative ring[13] on top of main assembly. Next place top[12] onto the decorative ring as shown and secure into place using the open finial[11].

3. Take threaded pipe[5] from parts bag and screw in screw collar loop[9] a minimum of 6 mm (1/4”). Lock into place with hexnut[6].

4. Run another hexnut down threaded nipple almost touching first hexnut. Now screw threaded pipe into mounting strap[2].
   Mounting strap must be positioned with extruded thread faced nto outlet box[4]. Threaded nipple must protrude out the back of mounting strap. Screw third hexnut onto end of threaded nipple protruding from back of mounting strap.

5. Connect mounting strap to outlet box using mounting strap screws[3].

6. Unscrew the threaded ring[8] from screw collar loop. Take canopy[7] and pass over screw collar loop. Approximately one half of the screw collar loop exterior threads should be exposed. Adjust screw collar loop by turning assembly up or down in mounting strap. Remove canopy.

7. After desired position is found, tighten both top and bottom hexnuts up against the bottom and top of the mounting strap.

8. Slip canopy over screw collar loop and thread on threaded ring. Attach chain[10] (with fixture connected) to bottom of screw collar loop. Unscrew threaded ring, let canopy and threaded ring slip down. Attach chain to fixture if required.

9. Weave electrical wire and ground wire through chain links no more than 3 inches apart. Pass wire through threaded ring, canopy, screw collar loop, threaded pipe and into outlet box.

10. Grounding instructions: (See Illus. A or B). A) On fixtures where mounting strap is provided with a hole and two raised dimples. Wrap ground wire from outlet box around green ground screw, and thread into hole.
    B) On fixtures where a cupped washer is provided. Attach ground wire from outlet box under cupped washer and green ground screw, and thread into mounting strap.
    If fixture is provided with ground wire. Connect fixture ground wire to outlet box ground wire with wire connector. (Not provided.) After following the above steps. Never connect ground wire to black or white power supply wires
    

11. Make wire connections (connectors not provided.) Reference chart below for correct connections and wire accordingly.
    
    

12. Raise canopy to ceiling.

13. Secure canopy in place by tightening threaded ring onto screw collar loop.

14. Install glass[16] by sliding up from the bottom of glass cage and seat into the inside bottom of cage as shown. Next bend over the tabs above the glass to secure into place. Repeat for all the glass panels.

15. Insert recommended bulb (Not supplied).

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>