KICHLER 45926CLP Dalwood 5.5-in 1-Light Classic Pewter Transitional Vanity Light Instruction Manual
- June 9, 2024
- KICHLER
Table of Contents
45926CLP Dalwood 5.5-in 1-Light Classic
Pewter Transitional Vanity Light
Instruction Manual
45926CLP Dalwood 5.5-in 1-Light Classic Pewter Transitional Vanity Light
CAUTION RISK OF SHOCK
-
Attach mounting strap[1] to outlet box[2]. Mounting strap can be adjusted to suit position of fixture.
Disconnect Power at the main circuit breaker panel or main fusebox before starting and during the installation. -
Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a hole and two raise dimples. Wrap ground wire from outlet box around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Put ground wire from outlet box under cupped washer and green ground screw and thread screw into hole in mounting strap.
-
Make wire connections. Reference chart below for correct connections and wire accordingly.
Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
---|---
Black| White
Parallel cord (round & smooth)| Parallel cord (square & ridged)
Clear, Brown, Gold or Black without tracer| Clear, Brown, Gold or Black with tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
*Note: When parallel wir es (SPT I & SPT II) are used. The neutral wir e
is square shaped or ridged and the other wire will be round in shape or smooth
(see illus.)
- Push fixture to the wall over mounting strap. Rest the mounting strap against the angled face (inside the canopy). Make sure all wires are inside canopy and do not get pinched between wall and canopy of fixture.
- Carefully thread mounting screws[3] through the holes in the top (or bottom) of canopy[4]. Tighten to secure fixture to the wall.
- Carefully raise the glass[5] to the fixture. Slip the smaller opening over the socket[6] and fit the glass against the socket cover.
- Thread the socket ring[7] onto the socket by using the spanner tool[8]. Tighten socket ring into place to secure the glass. (Do not over-tighten).
- Insert recommended bulb (Not supplied).
Date Issued: 09/15/17
IS-45926-US
Documents / Resources
|
KICHLER 45926CLP Dalwood 5.5-in 1-Light Classic Pewter Transitional Vanity
Light
[pdf] Instruction Manual
45926CLP Dalwood 5.5-in 1-Light Classic Pewter Transitional Vanity Light,
45926CLP, Dalwood 5.5-in 1-Light Classic Pewter Transitional Vanity Light,
Classic Pewter Transitional Vanity Light, Transitional Vanity Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>